The GP-250-M Welding Positioner is a positive drive rotary turn table complete with mounting flange, drive and tilt mechanism and Microprocessor based pulse width modulation motor control. The welding positioner is driven by a low voltage permanent magnet motor and gearhead power unit assembly. The microprocessor motor control enables operator interface of start, stop, clockwise rotation, neutral, counter clock-wise rotation and infinitely variable control of the speed, within the range of the positioner model.
The weld positioners rotation speed is electronically controlled using an optical tachometer located on the back of the gear-motor. Speeds within the range of the model are infinitely variable in both clockwise and counter-clockwise directions through a rotary speed adjustment potentiometer located on the remote control. Table tilt is manually set at any desired angle, from 0° through 90°, quickly and easily. Safety while using the positioner is greatly enhanced with Gullco’s low voltage (24V) control and power supply system. Positioner complete with table tilt manually set at any position through 90° with positive lock. Mounting plate with tapped holes for either a 12” (305mm) round table with six (6) radial slots, or a Gullco WPG-250 gripper. Alternately, above table and gripper can be mounted together on the positioner mounting plate.
This model includes the programmable remote control with LED readout and provides the following features:
- Infinitely variable rotation speed within the model’s speed range.
- Forward/neutral/reverse switch.
- Run/stop switch.
- Programmable microprocessor providing adjustable positioning timing cycles, amount of weld rotation, weld on/weld off through 360° and a signal to activate a pneumatically operated weld gun holder and wire feed arc activation.