CK TL26 Torch Parts FAQs
Torch bodies, back caps, handles and power cables for an air-cooled TIG torch, and how to choose the right replacement.
Should I choose a flexible or a rigid torch body?

A rigid body has a fixed angle and is usually described as giving more control when you walk the cup and as being more durable. A flexible body lets you set the neck to a chosen angle, which helps with awkward positions, tight corners and long runs where you would otherwise twist your wrist.
The trade-off is that a bendable neck is a moving part, so it can wear sooner than a fixed one. Pick on the work you do most, and bend a flexible neck only as the maker's instructions allow. Whichever you choose, it must be the right series and cooling type for your cable and consumables.
How do I tell if a torch body is worn or damaged?

Look for cracks or distortion, a loose or wobbling head, discolouration from overheating, damaged threads and damaged insulation. Check that the torch is physically intact and that the electrode and its fastening parts sit securely before each use.
Gas leaking at a joint can also point to the body or its seals, and a leak lets air into the shield, which can show up as porosity in the weld. Do not use a torch with damaged insulation, cracked parts or damaged cables. Replace the part first, and check the manual for the inspection steps that apply to your torch type.
Why does the back cap have an O-ring and when should I replace it?

The O-ring seals the rear of the torch head so shielding gas does not leak out and air is not drawn in. Air entering the gas stream is a recognised cause of porosity, along with gas line leaks, too high a gas flow and draughts.
Check the ring each time you remove the cap. Replace it if it looks cracked, flattened, nicked or hardened, and keep it lightly lubricated only if the maker's manual says so. If you suspect a leak, check each joint with an approved leak-detection fluid rather than guessing, and follow the manual and your gas supplier's advice for your equipment.
What is the difference between a one-piece and a two-piece power cable?

A one-piece cable carries the shielding gas and the welding current together, and connects through a gas-through fitting on the machine. A two-piece set keeps the gas hose separate from the power cable, so you connect the gas to the machine's gas outlet or to a regulator.
Which you need depends on how your welder is built and on the connector type on the machine. Some connector types, for example, need a separate gas hose for the gas connection. The torch end thread must also match the torch. Check the machine manual for its connection type and fit an adapter only if the maker allows it.