GF Performance Sawblades FAQs
Practical answers on matching, feeding and looking after mid-grade orbital pipe-cutting saw blades for tube and pipe.
What happens if I use a blade on a wall that is too thin for it?

When a coarse blade cuts a thin wall, only one or two teeth are in the material at any moment. Each tooth then takes a heavy load as it enters and leaves the tube, which can strip teeth from the blade or dull it early. Makers' guidance is to choose a pitch that keeps several teeth, commonly two to four, engaged in the cut.
If you see chipped or missing teeth on a blade that has only done a few cuts, check first that its stated wall range matches your tube, and that the feed is not too heavy.
How do I choose the blade diameter?

Blade diameter is usually set by the machine, so start with the machine's data plate and manual to see which diameters it accepts. Within that, machine makers advise using the smallest blade diameter and the coarsest pitch that is practical for the material and the speed involved.
The diameter also needs to be large enough to clear the tube you are cutting, so look at the maximum tube size the blade is stated to suit. A blade that is too small will not pass through, and one the machine was not designed for can be unsafe to run.
Do I need coolant or lubricant when cutting tube?

Machine makers' operating guidance says to make sure enough coolant is flowing over the cutting teeth, because heat and friction shorten blade life and spoil the cut finish. Stainless steel in particular tends to harden if the tool rubs rather than cuts, so a good flow of cutting fluid helps.
Which fluid and how it is applied depends on the machine and the material, so follow the machine maker's manual. Be aware that cutting fluid must later be removed from the tube end before welding.
Why does stainless steel dull a blade faster, and how do I avoid it?

Stainless steel work hardens: heat and pressure from a tool that is rubbing rather than cutting can make the surface harder, which then wears the next teeth even faster. Tool makers advise keeping tools sharp, running a suitable feed so the teeth cut instead of rub, and keeping the tool moving rather than letting it dwell in the cut.
In practice that means a steady feed (no stopping partway through), a cobalt-grade blade where the maker recommends one, and replacing the blade once it stops cutting cleanly.