Practical answers on choosing, fitting and using a portable tube end preparation machine with an internal wedge clamp.
Why prepare tube ends before welding?

A prepared end gives the welder access to the whole joint, so the weld can fuse properly right through the thickness. The risk of defects rises as the bevel angle or the root gap is reduced, and the root pass is usually the most difficult part of the joint.
A clean, square, accurately bevelled end also makes fit-up easier and more repeatable from one joint to the next. The exact preparation (angle, root face, gap) should come from your welding procedure or the relevant code, not from the machine.
What bevel angle and root face should I set?

There is no single right answer. The angle, the root face (land) and the root gap depend on the material, the wall thickness, the welding process and the welding procedure or code you are working to. The included angle is set by the need for correct torch or electrode access, and too narrow an angle or gap increases the risk of defects, while an excessive gap can cause melt-through.
Take the figures from your welding procedure specification, set the cutter accordingly, and check the first prepared end against the drawing before working through a batch.
How do I know when a cutter insert needs changing?

Trade guidance on cutting tools lists the usual warning signs: a poorer surface finish, rising cutting force, vibration or squealing, parts drifting out of size, visible wear or chipping, changed chip shape and tool life that is shorter than normal. The same guidance warns that waiting for a tool to break leads to scrap and damage to the holder.
Changing too late risks a spoiled tube end or a broken cutter, while changing too early wastes cutting edge that is still good. Turn or replace the insert as the manual describes, clean the seat first, and fit it with the screw tightened as the maker specifies.
What does an internal-clamp tube end preparation machine do?

It grips the inside of the tube with an expanding clamp on a central mandrel, then drives a cutter head round the tube end to face it square and cut the bevel in one set-up. Trade and patent descriptions of this type of tool explain that the clamps spread outwards as a draw rod pulls them along a taper, which centres the machine in a round bore.
Because the machine is held by the tube itself, it can be used on tubes that are already installed or cannot be moved to a lathe, such as tube banks and boiler work. The finished end is concentric with the bore.
Should I wear gloves when using the machine?

No, not around a rotating cutter. The HSE says many serious workshop accidents could be avoided if gloves were not worn close to rotating machinery. Its guidance also says to avoid loose or baggy clothing and jewellery, including rings, and to tie back long hair or wear a suitable hair net.
Keep the machine guarded, switch it off and let it stop before handling the cutter or swarf, and use suitable cut-resistant gloves only for handling sharp parts when everything has stopped. Follow the manual and your risk assessment.
How often should the machine be checked and serviced?

The HSE says inspection frequency depends on the type of work equipment, how it is used and the conditions it is exposed to, and should be set through risk assessment taking full account of the manufacturer's recommendations. It also says inspection does not replace servicing, which keeps the equipment in efficient working order and good repair.
In practice that means a quick look before each use (guards, cutter, clamp, air hose or cable) and a fuller check at the intervals in the manual. Take any machine with a damaged guard, cable or hose out of use until it is repaired.