Answers to common questions about variable-angle, locking air-cooled TIG torches, their interchangeable heads and consumables.
What should I check on the torch before each use?

Check the whole torch before each use: head, body, handle, cable, connectors and consumables. Look for cracked or loose cups, a burnt or deformed collet or collet body, damaged cable insulation or protective hose, sharp bends in the cable, and connectors that are not clean and tight.
TWI notes that the welder is responsible for checking the cable and coupling devices daily for damage, and that external connections should be clean and tight and checked after every reconnection. Replace a damaged cable rather than repairing it temporarily, and isolate the machine before changing parts.
How do I choose the right cup, collet and collet body for my tungsten?

Start with the tungsten diameter. The collet is sized to the tungsten, and TWI notes that nozzle selection depends mainly on the electrode diameter and on how accessible the joint is. Makers list collets and collet bodies by tungsten size, so match both to your electrode.
A standard collet body with an alumina cup suits general work. A gas lens body gives smoother, laminar gas flow, which TWI says improves gas protection on corner, edge and curved joints. Short and long cups are made for tight access and deep recesses. Always use parts made for the head series marked on your torch.
How far should the tungsten stick out of the cup?

Keep the stick-out as short as the joint allows, because the further the tungsten extends beyond the cup, the less shielding gas protects it. A standard collet body and cup limit how far the tungsten can reach before coverage suffers.
A gas lens spreads the gas more evenly through fine mesh screens and can take a larger cup, so it generally allows a longer stick-out into tight joints. The right distance depends on the cup size, gas flow and joint, so follow the torch maker's guidance rather than a fixed rule. With a longer stick-out, extra pre-flow helps the gas settle around the weld area, and adequate post-flow helps keep the tungsten clean.
Should I choose an air-cooled or water-cooled torch?

TWI notes that lower currents use smaller electrodes and air cooling, while higher currents need a larger torch to take larger electrodes and water cooling. An air-cooled torch is lighter, simpler and has no hoses or cooler to look after, which suits lighter or intermittent work.
If you will weld at high current for long periods, a water-cooled torch is the safer choice because air cooling relies on the surrounding air and shielding gas to carry heat away. Look at the current and duty cycle you will really use and choose a torch comfortably above it.
Should I choose a glass cup or an alumina cup?

Alumina (ceramic) cups are the sturdier general-purpose choice. A distributor's technical guide describes them as more durable than glass, while glass nozzles are clear but break more easily. A clear glass cup lets you see the tungsten and the weld pool, which is useful on fine work and in confined spaces.
Whichever you pick, match it to the head series and to the collet body or gas lens in use, since cups are made in sizes for particular heads. Larger-diameter cups give wider gas cover and long cups reach into recesses. Replace any cup that is chipped or cracked.
What do I need to match when I connect the torch to my machine?

Check three things: how the power cable connects to the machine, how the gas is supplied, and the fitting sizes. Makers list torches with a standard cable, where gas goes in by a separate hose, and a gas-through cable, where gas passes through the machine connector. Torches may also have a valve in the handle.
Power connectors come in more than one size, and thread sizes differ between makers and regions, so read the markings on the torch and your machine manual rather than assuming. If you need an adaptor, make sure it suits the connectors at both ends and the current you will use.