WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

GF Performance Sawblades

GF Performance Sawblades FAQs

Practical answers on matching, feeding and looking after mid-grade orbital pipe-cutting saw blades for tube and pipe.

How do I match the number of teeth to the wall thickness?icon-minus-redicon-plus-red

Makers of orbital tube saws normally pair a higher tooth count with thin walls and a lower tooth count with thicker walls, and list the wall thickness each blade is meant for. The aim is to keep enough teeth in the material at once so that the load is shared. Machine makers' guidance is generally to choose a pitch that gives roughly two to four teeth engaged in the cut.

Check the wall thickness of your tube, then pick the blade whose stated wall range covers it. If your walls sit at the edge of two ranges, ask our team or the machine maker rather than guessing.

What happens if I use a blade on a wall that is too thin for it?icon-minus-redicon-plus-red

When a coarse blade cuts a thin wall, only one or two teeth are in the material at any moment. Each tooth then takes a heavy load as it enters and leaves the tube, which can strip teeth from the blade or dull it early. Makers' guidance is to choose a pitch that keeps several teeth, commonly two to four, engaged in the cut.

If you see chipped or missing teeth on a blade that has only done a few cuts, check first that its stated wall range matches your tube, and that the feed is not too heavy.

How do I choose the blade diameter?icon-minus-redicon-plus-red

Blade diameter is usually set by the machine, so start with the machine's data plate and manual to see which diameters it accepts. Within that, machine makers advise using the smallest blade diameter and the coarsest pitch that is practical for the material and the speed involved.

The diameter also needs to be large enough to clear the tube you are cutting, so look at the maximum tube size the blade is stated to suit. A blade that is too small will not pass through, and one the machine was not designed for can be unsafe to run.

How should I feed the blade when cutting stainless steel?icon-minus-redicon-plus-red

Feed slowly and steadily. Machine makers advise using the slowest speed setting and a cobalt-type high speed steel blade for stainless steel, and say the rate of feed affects both the quality of the cut and the life of the blade. When feeding by hand, keep a steady, continuous pressure rather than forcing the blade through, because forcing can damage or break it.

On many orbital saws the handwheel is there precisely to give smooth, controlled feed. Take the speed and feed ranges for your machine from its manual.

Do I need coolant or lubricant when cutting tube?icon-minus-redicon-plus-red

Machine makers' operating guidance says to make sure enough coolant is flowing over the cutting teeth, because heat and friction shorten blade life and spoil the cut finish. Stainless steel in particular tends to harden if the tool rubs rather than cuts, so a good flow of cutting fluid helps.

Which fluid and how it is applied depends on the machine and the material, so follow the machine maker's manual. Be aware that cutting fluid must later be removed from the tube end before welding.

Why does stainless steel dull a blade faster, and how do I avoid it?icon-minus-redicon-plus-red

Stainless steel work hardens: heat and pressure from a tool that is rubbing rather than cutting can make the surface harder, which then wears the next teeth even faster. Tool makers advise keeping tools sharp, running a suitable feed so the teeth cut instead of rub, and keeping the tool moving rather than letting it dwell in the cut.

In practice that means a steady feed (no stopping partway through), a cobalt-grade blade where the maker recommends one, and replacing the blade once it stops cutting cleanly.