WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

HMT UltraLong TCT Cutters

HMT UltraLong TCT Cutters FAQs

Straight answers to the questions people ask most when choosing and using ultra-long carbide-tipped annular cutters.

What is an ultra-long TCT annular cutter?icon-minus-redicon-plus-red

It is a hollow, core-type cutter with tungsten carbide tips (TCT) on its cutting edge and a much deeper body than a standard cutter. It cuts only the outer ring of the hole and leaves a solid slug, so it needs less power than a twist drill.

The extra length lets it cut through very thick sections in a single pass, such as heavy plate, stacked material, thick flanges and large fabrications.

When do I need an ultra-long cutter instead of a standard one?icon-minus-redicon-plus-red

You need one when the thickness you must cut through is greater than the cutting depth of your standard cutters. Common cases are heavy plate, thick structural sections, built-up assemblies, and several layers clamped together.

If your standard cutter bottoms out before the hole is through, step up to a deeper one. Do not use a long cutter where a shorter one will do, as the extra length reduces rigidity and needs a suitable machine.

What machine do I need to run an ultra-long cutter?icon-minus-redicon-plus-red

A magnetic drill or other drilling machine with enough power, stroke and rigidity for the cutter's diameter and depth. The spindle must also take the cutter's shank fitting, either directly or through an adaptor.

Check the machine's stated maximum cutting depth and diameter, and whether the stroke is long enough for the full depth of the cutter. Underpowered machines stall or vibrate, which damages carbide tips.

Why use carbide-tipped cutters rather than high speed steel?icon-minus-redicon-plus-red

Carbide-tipped cutters hold their edge at higher cutting temperatures and tend to last longer in hard, abrasive or tough materials such as stainless steel. They are often chosen for production work.

Carbide is hard but can chip if it is shocked, run with vibration or used on a poorly clamped job, so it needs a rigid machine and careful set-up. For occasional or interrupted cuts, high speed steel may suit better. Check the manual for your cutter and machine.

What speed and feed should I use with deep cutters?icon-minus-redicon-plus-red

Follow the maker's speed recommendations for the cutter diameter and material, and run deeper cutters towards the lower end of the range if the machine shows any vibration. Use a steady, firm feed without forcing.

Hard materials and larger diameters need slower speeds. Carbide wants a constant feed: too light a pressure makes it rub and chip, too heavy overloads the motor. Reduce the feed if the swarf turns to dust rather than curls.

How important is cutting fluid with deep holes?icon-minus-redicon-plus-red

Very. In deep holes, swarf and heat have nowhere to go, so a steady supply of cutting fluid at the cutting edge is essential. Without it the tips overheat, the cutter jams and the slug can weld in place.

Use a fluid suited to the material and check that it reaches the cutting edge from the start. The way fluid is fed depends on the machine and cutter, so follow the manual for your own equipment. On very deep cuts, withdraw the cutter now and then to clear swarf if the instructions allow.