WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 0700000277  

    ESAB Outer Cover Lens - 88mm x 107mm (Pack of 25)
    0700000277

    £13.31  EX VAT
    SSP Suggested Selling Price = £17.75  YOU SAVE £4.44

    ESAB Albatross 4000X Parts FAQs

    Spare lenses, filter cassettes, headgear and fixings for a passive or auto-darkening welding helmet: what wears and how to buy the right one.

    Is it safe to keep welding with a scratched or damaged helmet part?icon-minus-redicon-plus-red

    Welding arcs give off ultraviolet and infrared radiation as well as bright light. Arc eye is an acute injury to the front of the eye that usually shows a few hours after exposure, so harm can be done before you notice anything.

    A scratched or pitted cover lens should be replaced. If the filter is cracked, damaged or does not darken when you strike an arc, stop welding at once and contact the supplier or maker, because the filter is not something to repair yourself. Stop using a helmet if a fault cannot be corrected. Follow your helmet manual and your risk assessment.

    When should I replace the outer cover lens?icon-minus-redicon-plus-red

    Replace the front cover lens once it is cracked, scratched or pitted, and clean the filter with a lint-free cloth rather than strong cleaning solutions. The inner and outer lenses are consumables, so expect to renew them over time using the lenses your manual specifies.

    How often depends on the process, the amount of spatter and how the helmet is handled. Replace the lens when it is damaged or when spatter has built up enough to hamper your view. Avoid resting the helmet on its front lens, which scratches it, and remove any protective film as the manual describes.

    How do I find the right cover lens for my helmet?icon-minus-redicon-plus-red

    Manuals list the front lens and the inner lens as separate parts, and the filter is only to be used with its inner lens in place, so check which one you need. Use the replacement parts your manual specifies, because lenses that look similar can sit badly or leave gaps.

    Check the manual or the markings on the helmet for the model, then match the shape and overall size of the old lens. If you cannot find a part number, measure the width and height in millimetres and note the type of filter fitted. Our team can help you choose if you send the helmet model and a photo.

    Why does my auto-darkening filter flicker or not darken?icon-minus-redicon-plus-red

    Start with the simple checks. Clean or replace a soiled or damaged front or inner lens, and wipe the sensors clean. If the welding current is low, the sensitivity may need turning up. Check the battery is in good condition, correctly fitted and has clean contacts. Headgear set unevenly can also cause patchy darkening, because the distance from your eyes to the filter differs.

    If the problem cannot be corrected, stop using the helmet immediately and contact the supplier or maker. Do not weld with a filter that does not darken reliably.

    Shop Similar Categories