Rapid Ref : 0700000415

ESAB Head Gear
0700000415

Name: ESAB Head Gear
SKU: 0700000415
Price: 7.89 GBP

£7.89 EX VAT

SSP Suggested Selling Price = £10.52 YOU SAVE £2.63

ESAB Air Fed Parts FAQs

Filters, seals, hoses and spares for one maker's powered air welding helmets: what each type of part does and how to choose and look after it.

What do the TH1, TH2 and TH3 markings mean when choosing air-fed spares?

Powered helmets and hoods with a loose-fitting head top are covered by the European standard EN 12941. It sets performance classes TH1, TH2 and TH3, with a higher number meaning better filtering and less leakage into the head top. Each class can be used with particle, gas or combined filters.

When choosing a replacement filter or other part, match it to the class and combination named in the maker's manual and on the data plate. The protection depends on the whole assembly of helmet, hose, blower unit and filter, so do not mix and match without the maker's approval.

Why check airflow before every shift, and what does a low-flow alarm mean?

A powered unit only protects if it provides enough filtered air to the head top. The HSE says maintenance of powered respirators includes checking the battery charge and the flow rate, and makers describe a simple flow indicator test before use. If the flow is below the minimum, do not use the unit until it has been examined and repaired.

If an alarm sounds while you are working, leave the work area and find the cause. A blocked filter, a flat battery or a leaking hose or seal are common reasons. Follow your own manual.

How do I know when to replace the particle filter on a powered air unit?

The right timing depends on the maker, the type of filter and how dusty or fumy the work is. The HSE says the manufacturer's maintenance schedule, including recommended replacement periods and shelf lives, should always be followed.

Typical signs a filter needs changing are shorter battery run time than before, a low-airflow alarm even with a charged battery, or damage. Heat, dust and spatter shorten life. Do not wash or tap out a particle filter unless the maker says that is allowed, and always fit the correct type for the unit.

How should I clean and store air-fed helmet parts?

The HSE says RPE should be stored according to the manufacturer's instructions, and that leaving it in dirty areas can contaminate the inside and deteriorate it through dirt, solvents and sunlight. HSE guidance adds that cleaning products other than those the maker recommends may cause problems.

In practice, clean parts as the manual describes, let them dry and keep them in a clean, dry place away from sunlight, heat and solvents. Keep spare filters in their sealed wrapping until needed.

See all 6 questions for this category