Orbitalum Cutting Heads for BRB 2 / BRB 4 FAQs
Bevel cutting heads for compact boiler-pipe preparation machines: what they do, how to choose one and how to look after it.
What does a bevel cutting head do?

A bevel cutting head fits on a compact pipe-end preparation machine and machines the end of a tube to a set weld angle, usually a V-prep. The machine holds itself inside the tube and the head turns round the tube end, so the bevel is cut square and can be repeated from one tube to the next.
The head replaces the plain tool plate on the machine, so the same machine can be set up for different jobs. Makers describe these machines as designed for boiler, tank and heat-exchanger work where there is little room between tubes. Always follow the manual for your machine when fitting a head.
How does the machine hold the tube while the head cuts?

These machines usually clamp on the inside diameter of the tube. A mandrel goes into the bore and clamping wedges expand against the inside wall, which centres the machine on the tube so the bevel is concentric with the bore.
Some machines use clamping wedges fixed to the mandrel so loose parts cannot fall into the tube, which matters on vertical work or in a tank. Others have pneumatic clamping that centres and clamps at the flick of a switch. The right mandrel and wedge set depends on the tube bore, so check the data plate and manual for your machine.
How do I choose the bevel angle?

Choose the angle that your welding procedure specification calls for. Cutting heads are normally made in a few standard angles, with 30, 37.5 and 45 degrees the common choices, and the angle is fixed by the head, so you need to buy the one that matches.
The angle, together with the root face and gap, sets the included angle of the joint, which controls how well the torch or electrode can reach the root. A wider angle gives better access but needs more weld metal. If you are not sure, ask whoever wrote the procedure or the welding coordinator before ordering.
What should I do before fitting or changing a cutting head?

Make the machine safe first. Before fitting a head, changing cutting bits or adjusting the clamping, disconnect the electric plug or shut off and disconnect the compressed air, and let the machine stop completely. The HSE says plant must be made safe before maintenance starts and that the work should only be done by competent people.
The maker's manual for this type of machine warns of flying chips and sharp edges and calls for safety goggles, cut-resistant gloves and safety shoes. It also warns that noise can exceed 80 dB(A), so wear hearing protection. Keep hands clear of the cutting bits and read the operating instructions before first use.