WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790086045  

    Orbitalum Adjustable Spacer for BRB 4 Machines
    790086045

    £496.00  EX VAT
     Buy in 3 easy interest free payments of £165.33† with

    Adjustable spacer for BRB 4 Machines, the adjustable spacer ensures a constant and repeatable depth machining of boiler pipes.

    Orbitalum Accessories for BRB / REB machines FAQs

    Answers on the clamping, lubrication and air-supply accessories used with portable pipe end preparation machines.

    How does inside-diameter clamping hold the pipe or tube?icon-minus-redicon-plus-red

    Portable pipe end preparation machines of this type are clamped from the inside. A clamping head fitted with a set of clamping wedges locates in the open end of the pipe and expands against the bore, so the machine is centred on the inside of the pipe. Makers describe the pipe dimension as quick to set for each wedge set.

    Because the clamp works off the bore, the inside diameter matters more than the outside diameter when you choose the wedge set. Check that the range on the data plate or in the manual covers the pipe, and keep loose scale, swarf and burrs out of the bore so the wedges seat properly.

    What are optional clamping wedges for?icon-minus-redicon-plus-red

    Clamping wedges are the parts that actually contact the pipe bore. A standard set covers a stated range of bore sizes, and makers list optional wedge sets specifically for extending that range, each shown against the pipe inside diameter it suits, so the same machine can take larger bores.

    Choose them by the inside diameter of the pipe, which depends on the outside diameter and the wall thickness, not by the nominal pipe size alone. Measure the bore if you are unsure, and check the machine's manual for which wedge set matches which bore range. Do not use a set outside its stated range.

    Why use cutting fluid when preparing stainless steel?icon-minus-redicon-plus-red

    Austenitic stainless steel work hardens, and its chips carry away little heat, so heat stays at the cutting edge and shortens tool life. Machining guidance says coolant is almost always crucial for these grades. Makers of pipe end preparation machines supply a water-soluble synthetic cutting fluid for this reason, to increase the service life of the cutting inserts.

    Use the fluid the machine maker recommends. Keep it off the surfaces that will be welded, and clean the pipe end as your weld procedure requires, because the weld preparation must be clean. How much to apply depends on the machine and the job.

    What should I check on the air hose and quick couplings?icon-minus-redicon-plus-red

    If your machine is air-driven, check the hose before each use for cuts, bulges, abrasion and other damage, and tag and replace any defective hose straight away. Safety guidance recommends a safety cable or whip check to stop the hose moving uncontrollably if a connection fails, and a mechanical lock on connections.

    Never run hose, couplings or the machine above the maker's pressure rating, make sure couplings are fully engaged and clean, and do not run the hose where it can be trodden on. The HSE has guidance on compressed air safety that covers portable pneumatic equipment, including inspection, maintenance and training.

    Shop Similar Categories