WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790086275  

    Orbitalum WH10-ID-80° Special Tool Holder (BRB 2 / 4 Machines)
    790086275

    £230.00  EX VAT
     Buy in 3 easy interest free payments of £76.67† with

    Orbitalum WH10-ID-80° special tool holder for cutting tubes from tube sheets, BRB 2 / 4 machines, 80° angle, 10mm max length.

    BRB 2 Tool Holders FAQs

    Answers to common questions about tool holders for portable orbital pipe and tube end-preparation machines.

    How do I choose the right tool holder for the weld preparation I need?icon-minus-redicon-plus-red

    Start with the joint you want to produce: a square (I-seam) face, a V bevel, or a curved J or U preparation. Each needs a differently shaped cutting edge, so the holder and its bit are normally chosen as a pair for that preparation.

    Then check the tube or pipe wall thickness, outside diameter and material, plus how the machine clamps the work. The weld procedure or your welding engineer should say which preparation and angle are required. If you are unsure, our team can help you match a holder to the job.

    What is the difference between I-seam, V and J (U) preparations?icon-minus-redicon-plus-red

    An I-seam is a plain square-cut face butted together; it is not strictly a bevel and suits thin walls. A V bevel is a straight angled face that forms a V when two ends are joined. A J (or U) preparation has a curved lower face and a land, so it needs less weld metal on thicker walls and is often preferred for orbital welding.

    J preparations are harder to machine than V bevels, which is why a dedicated holder and bit is used. The right choice depends on wall thickness, material and the weld procedure.

    Why does consistent end preparation matter so much for orbital welding?icon-minus-redicon-plus-red

    An orbital weld head cannot adjust for irregular edges the way a hand welder can. If the ends are not square, or burrs and defects leave gaps between the tube ends, penetration and the weld bead can become inconsistent around the joint.

    A holder that is rigid and correctly set, carrying a sharp bit, helps produce the repeatable face, land and bevel that automatic welding relies on. Check the finished ends before welding, and deburr or re-machine any that are poor.

    Do I need different tooling for stainless steel tube?icon-minus-redicon-plus-red

    Stainless steels, particularly austenitic and duplex grades, work-harden when the tool rubs rather than cuts. Use sharp bits with suitable geometry for the material, keep a steady feed rather than hesitating, and change bits regularly because a worn edge makes work hardening worse.

    A generous flow of suitable cutting fluid is also recommended. Keep the tool overhang short and clamp the tube firmly. Check the maker's guidance for your bit and material, and try a test piece first.

    Shop Similar Categories