WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : CK-2C4  Mfr Ref : 2C4

    Cup Ceramic 6mm Bore 13N14
    2C4 CK-2C4

    £14.03  EX VAT
    SSP Suggested Selling Price = £28.05  YOU SAVE £14.02

    Related Items

    Ceramic Cups FAQs

    Ceramic gas cups and gas lens cups for gas-cooled TIG torches: how to match them to your torch, choose a size and look after them.

    What is the difference between a standard cup and a gas lens cup?icon-minus-redicon-plus-red

    A standard cup is used with a normal collet body, where the gas leaves through small side holes and can swirl. A gas lens cup is used with a gas lens, which has fine screens that smooth the gas into a more even flow.

    The even flow protects the weld better and usually lets you extend the tungsten further out of the cup, which helps with joints that are hard to reach. For critical or high-quality work a gas lens is the usual recommendation, while a standard collet body is often enough for practice or non-critical welds. Check that your cup is made for a gas lens before ordering.

    How far should the tungsten stick out of the cup?icon-minus-redicon-plus-red

    A common rule of thumb with a standard collet body is to keep the tungsten extension to no more than about the inside diameter of the cup, though advice varies and many welders use less. A gas lens usually allows a longer extension because the gas flow is steadier, but there is still a limit.

    If the tungsten sticks out too far, shielding suffers and you may see discoloured tungsten or a porous weld. Set the extension as short as the joint allows, and check the tungsten colour and weld appearance. Your torch maker's instructions and your welding procedure take priority over any general rule of thumb.

    How do I set the shielding gas flow for a given cup?icon-minus-redicon-plus-red

    Use the lowest flow that still gives good protection, and measure it with a flowmeter rather than guessing. Too much gas increases turbulence and the risk of drawing in air, while too little leaves the weld pool and hot tungsten poorly shielded.

    The right setting depends on the cup, the torch, the joint and the surroundings, so there is no single figure. Draughts usually call for more care, not just more gas. Set a post-flow time on the machine so the gas keeps protecting the tungsten while it cools; the machine's manual explains how to adjust it.

    How do I find out which ceramic cups fit my torch?icon-minus-redicon-plus-red

    Cups are made for a particular torch series, and parts from different series are often not interchangeable. Start with the torch itself: the series or model is usually marked on the torch body, the handle or the packaging, and the manual normally has a parts list.

    Also check which collet body type you have, because a gas lens cup needs a gas lens and a standard cup needs a standard collet body. If you are unsure, compare the thread, the seating end and the bore of your old cup with the new one before ordering, or ask our team to help you match it.

    Shop Similar Categories