CK 2 Series Stubby Parts FAQs
Short back caps, short collet bodies and related spares for compact TIG torch heads: how to identify, fit and look after them.
Why does a short back cap need shorter tungsten?

A short back cap has limited internal depth, so a full-length electrode will not fit behind the collet. The tungsten may need to be cut down so the cap can screw fully onto the torch.
Some welders use up worn electrodes this way, and keep a few short pieces ready for confined work. Make sure the stub is long enough for the collet to grip it firmly and for the tip to reach the correct stickout. Follow the torch manual for the length the cap allows, and for how to prepare the tungsten.
What is a short collet body and which parts does it work with?

A short collet body is a shorter version of the part that holds the collet and feeds gas to the cup. It is designed to be used with a matching short collet and a short cup, which together give the compact head.
It sits in the same place as a standard collet body, but the parts are sized as a set, so mixing lengths may not seat or seal properly. It also needs the right insulator or heat shield, and its size must match the tungsten diameter. Check the torch series and the parts list before ordering.
What is a reverse collet and how does it differ from a standard one?

A reverse collet is generally described as a shorter style of collet with the slots at the opposite end to a standard collet, so it seats at the back of the body instead of sliding fully inside it. This helps keep the head compact. Descriptions vary between suppliers, and whether it can be used with a standard body depends on the torch design, so check your torch parts list rather than assuming.
As with any collet, it must match the tungsten diameter, and it grips the electrode when the back cap is tightened. Replace it if it feels loose, is distorted or shows burn marks, because a poor grip can let the tungsten move or overheat.
How do I match stubby parts to my tungsten diameter?

Collets and collet bodies are made in sizes that correspond to tungsten diameters, usually shown as an inch or millimetre size or a size code. Each part should match the electrode you plan to use. If you change the electrode size, change the collet and body too.
The size is usually marked on the part or shown in the parts list. Where a part has no clear marking, compare it with your torch manual or measure the tungsten with a gauge rather than guessing. Do not force an electrode into a collet of the wrong size.