WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : CK-HS  

    CK Small Torch Handle
    CK-HS

    £7.85  EX VAT
    SSP Suggested Selling Price = £15.70  YOU SAVE £7.85

    Suitable for:

    • CK9, CK20, CK24, CK25
    • CK100, CK130, CKPF130
    • CK200, CKPF200, CKT200
    • MR70, MR140

    CK MR140 Torch Parts FAQs

    Spare parts for a water-cooled micro TIG torch: what wears, what each part does and how to match the right replacement.

    How do I identify the right replacement parts for my micro torch?icon-minus-redicon-plus-red

    Start with the torch's own markings and the maker's manual, which normally includes a parts list or diagram. If you still have the old part, note any number on it and measure the thread, the length and the electrode size it holds. Torch styles differ, so a cup, collet body or back cap that looks the same may not fit; check the style before ordering.

    Makers advise using their own listed replacement parts rather than adapting something close. If you are unsure, send our team a clear photo of the torch head and the part you want to replace and we can help you match it.

    When would I use a gas lens instead of a standard collet body?icon-minus-redicon-plus-red

    A gas lens takes the place of the standard collet body and passes the shielding gas through fine mesh, which reduces turbulence and gives smoother gas coverage. Torch makers say this can allow a longer tungsten stick-out, which helps you see the weld pool and reach into tight joints. A standard collet body is simpler and often perfectly good for everyday work with a short stick-out.

    Only the body changes. Check your manual for the collet type and the cup that your torch takes with a gas lens, and make sure both match the tungsten diameter. The fine mesh can become dirty or damaged, so inspect it whenever you change the electrode.

    What should I check on the power cable, gas hose and water hoses?icon-minus-redicon-plus-red

    Switch off the power source, disconnect it from the mains and shut off the gas and coolant before handling the cable assembly. Then check the cable and its insulation, the gas hose, the water hoses and all connectors for cuts, kinks, heat damage or looseness, and keep the contact surfaces clean so they make good electrical contact. Check the insulation on the handle and other insulated parts too.

    Torch makers say to replace damaged parts rather than make temporary repairs. Do not use a torch with a damaged cable or connector, and have any repair to the cable assembly done by a competent person following the maker's manual.

    What should I know about thoriated electrodes when buying spare tungsten?icon-minus-redicon-plus-red

    Thoriated tungsten contains a small amount of radioactive thorium. The greatest hazard is the fine dust made when grinding, not the welding itself, so grinding should be done on a dedicated wheel with local dust extraction, with suitable respiratory protection worn unless only a very small number of electrodes is ground, and eye protection if the wheel has no viewing screen. Ceriated or lanthanated electrodes are generally acceptable alternatives, and using a thoriated type should be justified.

    HSE guidance on welding fume points to local exhaust ventilation for regular TIG welding indoors. When you buy spare tungsten, check the type marking on the pack and the safety data sheet, and consider in your risk assessment whether a thorium-free type would do the job.

    Shop Similar Categories