Straight answers to the questions people ask most when choosing and running an air compressor.
What is the difference between a portable and a static compressor?

A portable compressor is built to be moved around, usually on wheels or a frame with a handle, and normally has a smaller tank. It suits workshops that need to move the compressor to the job, or jobs on different sites. A static compressor is fixed in one place, usually with a larger tank, and is designed to supply a workshop through a fixed pipe system.
Static machines are typically bigger and built for longer running. Choose by where and how the air will be used.
What is the difference between piston and screw compressors?

Piston (reciprocating) compressors are the most common in workshops. They are simple, robust and suit intermittent use, as the pump runs, fills the tank, then stops. Rotary screw compressors are made for continuous heavy use, are quieter and can run all day, but are bigger, more complex and suit larger industrial demand.
For most small and medium workshops a piston compressor is the usual choice. If you need air constantly for a production line, a screw compressor is worth considering.
What do litres, CFM and bar mean on a compressor?

The tank volume in litres tells you how much air is stored. The flow, often quoted in cubic feet per minute or litres per minute, shows how much air the compressor can supply, and is the most important figure for running air tools. The pressure, in bar, is how hard the air is pushed.
A large tank with a small pump will run out of air quickly under load, while a good flow rate lets you run tools for longer. Look for the real output flow, not just the pump's displacement, and check both against the tools you use.
What is the difference between an oil-lubricated and an oil-free compressor?

Oil-lubricated compressors use oil to lubricate and cool the pump. They are often durable and suit heavy use, but need regular oil checks and changes, and a little oil can carry into the air. Oil-free compressors need no oil in the compression chamber, so they need less oil servicing and give cleaner air.
Noise, wear and life vary with the design and size, so compare machines rather than assuming. For spraying or other clean air needs, oil-free is attractive, though filtration is still needed. Check the maker's data for the type of use you plan.
Do I need an air dryer and filters?

Compressing air squeezes out moisture, and the air also picks up oil and dirt from the system. Water in the lines damages tools, spoils paint and can corrode the system. A filter and a moisture separator at the compressor or at the point of use catches much of this. A dryer takes it further.
For air tools, a basic filter-regulator and regular draining are normally adequate. For spraying, plasma cutting and other clean-air uses, you will want better filtration and drying.
How should I look after an air compressor?

Drain the tank regularly to remove condensed water, because water left in the tank causes corrosion. Check the oil level on oil-lubricated machines and change it as the handbook says, clean or replace the air intake filter, and check belts, hoses and fittings for wear and leaks.
Keep the compressor in a clean, well-ventilated space, and turn it off and release the pressure before any maintenance. Regular care keeps it running reliably and safely.