Straight answers to the questions people ask most when choosing and using exothermic cutting equipment.
How does exothermic cutting work?

An exothermic cutting rod is a steel tube filled with metal rods. The rod is held in a torch, a stream of oxygen is fed through the tube, and the end of the rod is lit with an electrical spark or arc from a battery or welding power source. Once lit, the rod burns fiercely in the oxygen, giving off very intense heat that melts and blows away the material in front of it. It keeps burning as long as the oxygen flows.
Unlike ordinary gas cutting it needs no fuel gas, and it does not depend on the material burning in an oxygen jet, which is why it can cut things other processes cannot.
What can an exothermic torch cut?

It is used on materials that are hard to cut by other means: carbon steel, stainless steel, cast iron, aluminium and other non-ferrous metals, as well as slag, refractory material, concrete and brick. It also cuts through rusty, dirty, painted or corroded metal, where other processes struggle.
It is common in demolition, scrap cutting, maintenance and repair, and rescue and recovery work, and for cutting out seized or damaged parts. It makes a rough cut with a lot of molten material, so it is not used where a neat edge matters.
What are the safety risks and what protection do I need?

Exothermic cutting is a very hot, hazardous process. It throws out large amounts of molten metal and slag, sparks and intense light, and the rods burn at extremely high temperature. The oxygen supply greatly increases the fire risk, so clothing and anything flammable can ignite far more easily.
Wear flame-resistant clothing that covers you fully, heavy gloves, safety boots, and a face shield or helmet with the right filter. Clear the area of combustible material, have a fire extinguisher to hand, make sure nobody is behind or below the cut, and follow your hot work procedures. Fume can be harmful, so ventilate or use respiratory protection as your risk assessment requires. Never use it where flammable gas, vapour or dust may be present.
What oxygen supply and regulator do I need?

Exothermic cutting uses a large amount of oxygen, so the cylinder and regulator must be able to provide the flow and pressure the torch maker specifies. A light-duty welding regulator may not pass enough flow. Use a regulator designed for oxygen and rated for the pressure and flow required, and fit any protective devices the maker specifies.
A cylinder empties quickly at high flow, and a larger cylinder or several cylinders joined together give longer cutting time. Keep oxygen equipment away from oil and grease, which can ignite violently in pure oxygen.