Straight answers to the questions people ask most when choosing and using bevelling and weld preparation machines.
What types of bevelling machine are there, and what is each for?

Plate-edge bevelling machines are portable machines that travel along the edge of a plate with a milling or cutting head, producing a smooth bevel in one pass for weld preparation. Pipe-end preparation machines clamp inside or outside the pipe and use tools to face, bevel and sometimes counterbore the end. Cutting and bevelling carriages run on a track and carry a torch, usually plasma or oxy-fuel, to cut and bevel in one pass.
Which you need depends on whether you are preparing plate or pipe, the thickness and material, and whether you want a machined finish or a thermally cut one.
What do V, U and I preparations mean?

These describe the shape of the joint edge before welding. An I (square) preparation is a flat square end with a small gap. A V preparation has an angled face on each piece, forming a V groove. A U or J preparation has a curved profile, used on thicker material to reduce the amount of weld metal needed. A double-V or K preparation is bevelled from both sides on thick plate, to reduce distortion and filler.
The right choice is set by your welding procedure and the code, material, thickness and process you are working to. Follow the procedure rather than choosing by habit.
What is the root face, and why leave one?

The root face, also called the land, is a small flat left at the bottom of the bevel, below the sloping face. It supports the arc at the root, helps prevent burn-through and keeps the root gap consistent. Without it the edge can become a feather edge that melts away too easily.
The size of the root face and the bevel angle come from the welding procedure, and depend on the process and the thickness. Many machines and tool holders cut the bevel and leave the land in one operation. An inconsistent root face leads to uneven penetration, so check it with a gauge.
How do I know what thickness and bevel size a machine can handle?

Machines state a maximum bevel width or material thickness. Choose a capacity for the thickest material and largest bevel you will make, with some margin. Harder materials such as stainless steel and high-strength steels reduce what the machine can do in one pass, and large bevels may need more than one pass.
Also consider the minimum thickness, the condition of the plate surface (mill scale, rust, flame-cut edges) and which bevel angles the machine can produce, since some are fixed by the tool and others are adjustable. Our team can help you match a machine to the work.
Should I use a cold-cutting bevelling machine or a thermal carriage?

A cold-cutting machine removes metal by milling, leaving a clean, machined surface that is ready to weld, with no heat-affected zone and no oxide or slag. That makes it the preferred choice for stainless steel, alloy steels and other work where specifications restrict thermal cutting.
A plasma or oxy-fuel carriage is quick on thick carbon steel and can cut and bevel in one pass, but the edge is thermally cut and normally needs grinding or cleaning to remove oxide, slag and any hardened layer before welding. Choose according to the material, the weld specification and the finish you need.
How do I choose a pipe bevelling machine for my pipe?

Start with the outside diameter, wall thickness and material of the pipe, and whether the machine clamps inside or outside it. Check that the clamping range covers your sizes, because larger pipes may need different clamps or extension wedges. Then consider the preparation you need, such as single V, U or J, square facing or counterbore, and whether tool holders for those are made for the machine.
Think about where you will use it, whether you have electricity or compressed air, and how much it weighs if it has to be carried. Our team can help you choose.