CK Stubby Series - Gas Lens FAQs
Straight answers to the questions people ask most when choosing and using stubby gas lens parts for a TIG torch.
What is a stubby gas lens set-up and when is it worth choosing?

A gas lens set-up replaces the standard collet body with a body containing fine mesh screens, so the shielding gas leaves the cup as a smooth, steady column. The stubby version is a shorter front end, which helps you get the torch into restricted spaces and keeps the weld easier to see, especially when it is used with a short back cap.
It is most worthwhile when you need extra tungsten reach, work on joints with poor access, or weld materials that need good gas cover, such as stainless steel. For simple, open joints with short tungsten extension the difference may be small.
How is a gas lens different from a standard collet body?

A standard collet body passes the gas through a few small side ports, so the flow has little direction and can become turbulent. A gas lens spreads the gas through layers of fine stainless mesh first, so it comes out evenly and with less turbulence. That gives better cover of the weld pool and the area around it, and it allows the tungsten to stick out further.
The collet itself is still used, and the gas lens takes the place of the collet body. With a very short tungsten extension you may not notice a big change.
What does the heatshield do on a gas lens set-up?

The heatshield, sometimes called a gas lens insulator, fits behind the cup and protects the head of the torch from the heat of welding. It also helps to give a gas-tight seal between the gas lens and the cup, so shielding gas is not lost out of the back.
It is a normal part of a gas lens conversion rather than an optional extra. Stubby and full-size parts do not always interchange, so choose the heatshield made to suit your gas lens and cup, and replace it if it is cracked, scorched or no longer seals.
Why do the parts need to match my torch series and tungsten size?

Collets, collet bodies and gas lenses are made for a particular torch series and for a particular tungsten diameter. The collet must match the tungsten size, and the gas lens or collet body must match the collet, so a 2.4 mm tungsten needs a 2.4 mm collet and body. A mismatched part grips badly, can leak gas or arc inside the head.
To identify your torch, look for the series number marked on the torch head or in the handbook (for example 9, 20, 17, 18 or 26). Body length alone is not a reliable guide, because short stubby bodies also exist for the larger series. Always check the torch markings and manual.