Answers for choosing, fitting and looking after a mid-range gas-cooled TIG torch and its consumables.
Is an air-cooled torch rated around 200 amps enough for my work?

Air-cooled torches are common for work at or below about 200 amps, and they rely on the surrounding air and the shielding gas to carry heat away. They are simpler than water-cooled torches and need no separate cooling unit.
The rating only means something with its duty cycle. Duty cycle is measured over ten minutes, so a 60% rating means about six minutes of welding and four minutes of cooling. Running above the rating heats the handle and cable faster and the duty cycle drops. For long, high-current welding a water-cooled torch is usually the better choice. Check the data plate and manual.
What does a gas lens do, and is it worth fitting?

A gas lens replaces the standard collet body and uses a series of metal screens to diffuse and spread the shielding gas, giving a smoother flow that reaches further from the cup. It is generally recommended for DC welding because it improves weld quality and can let you use less gas, and it is less important for AC aluminium.
It also lets you use a longer tungsten stick-out, which helps get into corners and around joints. A gas lens is often used with larger cups. Gas-saver style kits bundle the lens body, collets and cups together; make sure the kit is for your torch series.
How do I choose the right cup size?

Cup numbers reflect the inside diameter in sixteenths of an inch, so each step up adds about 1.6 mm. Regular collet bodies take smaller cups, while gas lenses take a wider range, including larger cups that need extra screens to spread the gas evenly.
A larger cup gives wider gas cover and lets you use a longer stick-out, but is bulkier and can hinder access and the view of the joint. A smaller cup helps in tight corners. As a starting point, use a flow in litres per minute close to the cup number, and adjust for your joint and draughts.
How do I make sure a cup, collet or other consumable fits my torch?

Torches come in families, often called series, and parts are not interchangeable between them. A cup made for one torch style will not necessarily fit another, so you need to know your torch style before ordering.
Check the series on the torch body or in the manual, then match the collet to the tungsten diameter and the collet body or gas lens to the torch series. Cups, collet bodies, back caps and heat-related parts are normally sized for a particular series. If in doubt, our team can help you identify the correct part.
Which tungsten electrode should I use?

For DC work on steel and stainless, ceriated and lanthanated electrodes are widely used. Ceriated tungsten starts well at low current and suits small, delicate work, and lanthanated tungsten is a widely used non-thoriated alternative.
Thoriated tungsten is slightly radioactive. If you grind it, the dust is the main hazard, so use dust extraction at the grinding station, keep the area clean and follow the maker's safety data sheet. Grind with the marks running along the length of the electrode, because angled or spiral marks can make the arc unstable. Match the diameter to your current and collet.
What ventilation do I need when TIG welding?

The HSE says welding fume, including irritating gases such as ozone, may cause respiratory irritation and metal fume fever, and that ozone in particular can affect TIG welders working on stainless steel and aluminium. For regular or intensive TIG welding, HSE guidance is local exhaust ventilation, with respiratory protective equipment as well where that alone is not enough.
HSE guidance says that even for occasional welding (less than once a week and under an hour), respiratory protective equipment and good general ventilation should be provided, and that open doors and windows are not usually sufficient. Your COSHH assessment should decide the controls for the material and the work.