Straight answers to the questions people ask most when choosing a complete source extraction package for welding fume.
What does a source extraction package include?

A package brings together the parts needed to capture fume at the point it is made: usually a capture device such as an arm, hood, table or fume torch, a fan, and a filter unit. Some packages also include controls, mounting parts and ducting.
Buying a matched package helps make sure the airflow, the filter and the capture device work together, rather than relying on parts picked separately that might not suit each other.
How do I choose between an arm, a hood, a table and a fume torch?

It depends on the work. An extraction arm suits work that moves around a bench or small area. A hood suits repeat work in a fixed position. A downdraft table suits bench work on small to medium parts. A fume torch captures fume at the arc itself and suits MIG welding where an arm would get in the way.
Think about the part size, how often you reposition, the process and how many welders there are.
Should the package be mobile or fixed?

A mobile unit moves to where the work is and suits varied jobs, small workshops and sharing between stations. A fixed unit is permanently installed, handles more welders or heavier use, and keeps the floor clear.
If welding always happens in the same place, fixed is often more satisfactory. If your work moves, a mobile unit gives flexibility, but it must be moved and positioned correctly each time.
How many extraction points can one unit serve?

A single filter unit can serve one or several capture devices, but only within its airflow capacity. Each arm or hood needs enough air to capture properly, and adding more points on one fan reduces what each gets.
Check the unit's capacity against the airflow each capture device needs. If several welders work at once, the unit must be able to give each of them full capture at the same time.
Do I need to filter and recirculate the air, or duct it outside?

There are two routes. Ducting the fume outside removes it from the building but needs fresh air to replace it and a discharge point away from windows, doors and air intakes. Filtering and returning the air saves heating, but only works if the filter is right for the fume and is kept in good condition.
Recirculation is not suitable for every material or amount of fume, and a loaded or poorly chosen filter can let fine particles back into the workshop. Check the data plate and manual for your own machine, take advice if you weld stainless steel or other materials with more hazardous fume, and let your risk assessment decide.
What does the filter do, and what kind should I choose?

The filter traps the fine particles in welding fume before the air is returned or released. Types range from disposable cartridges and bags to cleanable and self-cleaning systems, some with extra stages for finer particles or gases.
Choose according to the material welded, the volume of fume and how much maintenance you can manage. Check that the filter is suitable for the specific fume you produce.