CK 2 Series Standard Parts FAQs
Answers on choosing, fitting and looking after the standard collets, collet bodies, back caps and ceramic cups for a small TIG torch.
Is grinding thoriated tungsten a health concern?

Yes, grinding is the main hazard with thoriated electrodes because it creates fine, slightly radioactive dust that can be inhaled. Typical controls are a dedicated grinding wheel with local dust extraction, sealed bags for the dust and washing facilities nearby.
Ceriated and lanthanated electrodes are common alternatives, especially for DC work, and zirconiated types are often used for AC. Your employer's risk assessment and the maker's instructions decide what is right for your work.
What do the collet and the collet body each do, and why must they match the tungsten?

The collet grips the tungsten electrode and passes current to it. The collet body holds the collet and directs shielding gas towards the cup. The collet must match the tungsten diameter, and a trade article on torch set-up stresses a tight fit between collet and electrode for good conductivity and a stable arc.
Use a collet body of the matching size for the same torch family. A wrong-size, worn or overheated part can let the electrode slip or make poor contact, so replace any part that looks discoloured, distorted or damaged.
What is a wedge collet and how does it differ from a split collet?

A split collet has a slit at its rear and is squeezed onto the tungsten when the back cap is tightened. A wedge collet has no slit; the back cap drives its tapered end into the collet body or gas lens to lock the tungsten.
A welding-equipment maker's troubleshooting guide says the ordinary split style can twist or jam and suggests trying a wedge style when collet life is short or the torch heats up inside. Sellers also claim a firmer grip, but treat that as a sales claim. Either type must match your torch family and the tungsten diameter.
Why is my tungsten loose or my arc wandering?

Check the hardware first. A worn or wrong-size collet, a collet body that is not snug in the torch head or a loose back cap can all let the tungsten move. Replace worn or discoloured parts rather than over-tightening them.
Then look at the electrode. A welding-equipment maker's data sheet advises grinding lengthways so that ridges do not cause arc wander, and its troubleshooting guide lists a contaminated electrode, too long an arc and too little current for the electrode size as causes of an erratic arc. Cut off and re-prepare a contaminated tip.