Gullco KAT Track Sections FAQs
Answers to common questions about the track sections that guide welding and cutting carriages.
What is the difference between rigid and flexible track sections?

Rigid track cannot be bent. It is suited to flat work and straight seams, and to out-of-position welding where stability is essential. Flexible track can be bent to follow a gentle curve, such as a tank shell or a large pipe.
Flexible track has a minimum bending radius set by the maker. Bending it tighter can affect stability and torch movement and may damage the track. Heavy carriage loads generally sit better on rigid track.
Check the radius of your work against the maker's stated limits before you buy.
How is track held to the work?

Track is usually fixed with magnetic units on ferromagnetic material such as carbon steel, or with vacuum units. On stainless steel, aluminium and other non-ferrous metals magnets do not hold, so vacuum or mechanical clamping is required.
Flexible track on curved vessels often needs extra brackets or clamps. Whichever method you use, make sure the track cannot shift or lift under the weight of the carriage, particularly on vertical or overhead runs, and follow the maker's instructions.
What happens if my work is tighter than the minimum bend radius?

Each flexible track is made with a specific minimum bending limit. Bending it beyond that can reduce stability, interfere with torch movement or damage the track itself.
If your curve is tighter than the track allows, you need a different type of track made for tight curvature or full circumference work, or a different way of guiding the torch. The limit depends on the track, so check the maker's data before you plan the set-up, and do not force a section round.
Why are track sections made from aluminium alloy?

Aluminium alloy is light, which makes long sections easier to carry and fix, and it does not rust. The trade-off is that it can dent or bend if dropped or knocked, and it expands with heat more than steel does, roughly twice as much, so avoid putting it close to the arc or leaving it in direct heat.
A bent or dented track makes the carriage travel unevenly. Handle sections carefully, store them flat, and replace any that are damaged. Check the maker's guidance for any limits on use.