WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

HMT CarbideMAX TCT 80 Cutters

HMT CarbideMAX TCT 80 Cutters FAQs

Straight answers to the questions people ask most when choosing and using deep 80 depth tungsten carbide tipped broach cutters.

What is a deep annular cutter for?icon-minus-redicon-plus-red

A broach (annular) cutter removes a ring of metal and leaves a solid slug, which is much more efficient than drilling a full-diameter hole. A deep cutter has a long cutting depth, measured in millimetres.

It is intended for thick plate, heavy structural sections, stacked material and deep cuts that shorter cutters cannot reach. It is used in a magnetic drill or similar rigid machine. Check the data plate and manual for your own machine to confirm the depth and diameter it is rated for.

How do I know I need a deep cutter?icon-minus-redicon-plus-red

Add up everything the cutter must pass through, including both walls of a hollow section, packers and stacked plates. If the total approaches the depth of a shallower cutter, step up a series.

Deep cutters are longer and need more power, so do not use them for thin work out of habit. Pick the shallowest cutter that gives a comfortable margin over the material thickness.

Does a deep cutter need a special pilot pin?icon-minus-redicon-plus-red

Yes. Pins are made for specific depth series and diameter ranges, and a deep cutter needs a pin of the right length and fit. Some deep cutters use a one-piece pin design.

Check the diameter range and series on the pin against your cutter. A wrong pin may not eject the slug, may not seat properly or may leak coolant.

What machine do I need?icon-minus-redicon-plus-red

A deep cutter needs a powerful, rigid magnetic drill with enough stroke to travel the full depth, a strong magnet and a sound spindle. Deep cuts at large diameters create high torque.

The magnetic base must sit on clean, flat steel that is thick enough to hold firmly. Check the shank type fits your machine and use the safety strap or chain provided.

Why do deep cuts need extra attention to coolant?icon-minus-redicon-plus-red

The deeper the cut, the harder it is for fluid to reach the teeth and the more heat is generated. Without enough lubrication the teeth overheat, the swarf welds to the cutter and the life of the cutter drops sharply.

Use suitable cutting fluid fed through the pilot pin, keep the reservoir topped up and watch that flow does not stop during the cut.

What speed and feed should I use?icon-minus-redicon-plus-red

Follow the cutter maker's guidance. As a general rule, larger diameters and harder materials need slower speeds, and deep cuts benefit from steady, consistent feed.

Look at the swarf: clean curled swarf means the feed is about right. Dust, sparks or blue discoloured swarf suggests the feed or speed needs adjusting, or that coolant is lacking.