Practical answers on choosing and using top cases for impact drilling, reaming, threading and rivet removal bits.
What is an impact reamer used for?

On steel structures, holes in joining members are sometimes slightly out of line. A reamer removes a little material so the holes line up and the bolt can pass without force, and a tapered tip helps it enter holes that are not quite aligned.
It is for correcting small misalignments, not for drilling new holes. Take off only the minimum needed, because enlarged holes can affect the joint. On structural steelwork, check the project specification and ask the designer or engineer before reaming, and do not use a reamer to cover up badly mismatched holes. Not every reamer is built for impact driver use, so check the maker's information.
What is the difference between a thread die and a thread chaser?

A thread die is a cutting tool that makes a new external thread on a bar or rod. A thread chaser is designed to clean, re-form and restore an existing thread that is dirty, rusty or lightly damaged.
A cutting tool run over a damaged thread can remove more thread material than you want, so a chaser is the gentler choice where most of the thread is intact. Chasing only works if enough thread remains: if a bolt or stud is stripped, galled or badly mangled, replace it. Check the thread size and pitch first, and use cutting fluid when cutting a new thread.
How do I remove a rivet with a drill?

The usual method is to drill into the rivet head only, as far as the surface of the metal, so the head can be removed. The remaining shank is then driven out with a punch slightly smaller than the shank.
The aim is to avoid distorting the metal or elongating the rivet hole, so keep the drill square to the work, drill no deeper than needed and support the part so it cannot move. Wear eye protection, and check the repair instructions for the equipment first, as some jobs call for a specific method.
Do I need cutting fluid when drilling stainless or tough steel?

Using an adequate supply of cutting fluid or coolant is good practice when drilling tough materials. Stainless steel in particular is far more prone to work hardening than ordinary steel, which makes the next cut harder and wears the bit faster.
Keep the bit cutting a proper chip with a steady feed rather than letting it rub or dwell in the hole, because rubbing and repeated pecking tend to harden the surface. Clear swarf regularly, and apply fluid as the maker directs. Check the cutting fluid's safety data sheet before use.
Does a sharp bit really make a difference to vibration and speed?

Yes. HSE advises checking tools before use to avoid the extra vibration caused by faults or general wear, and keeping cutting tools sharp so that they stay efficient. A worn drill bit makes you push harder, builds heat and can leave a rough hole.
Check your bits for a dulled cutting edge, chipped lips, bluing from heat or bending. Replace damaged bits rather than forcing them. Bits that cut cleanly need less pressure, which is better for the hole, the driver and your hands.
How long can I use an impact tool before vibration becomes a concern?

There is no single safe time, because it depends on the tool, how it is used and the person. HSE gives a rough guide that hammer-action tools used for more than about 15 minutes a day, or some rotary and other action tools for more than about an hour a day, may mean a vibration exposure problem. Real limits depend on the maker's vibration data.
Watch for tingling and numbness in the fingers, not being able to feel things, or loss of strength in the hands, and report them early. Check the maker's vibration figures and your employer's risk assessment, and plan job rotation and breaks to cut the time the tool is actually running.