Powered air-fed welding and grinding helmet systems: what they do, how to check them and how to look after the blower, filters, battery and tube.
Can a powered air helmet replace fume extraction?

Not on its own. General ventilation does not give the control that is expected for welding fume, and indoor welding normally needs suitable engineering controls, typically local exhaust ventilation. Respiratory protective equipment is then used for whatever fume the extraction does not capture. Outdoors, where extraction is often impractical, suitable respiratory protection is expected.
A powered helmet is therefore best seen as the last layer of protection, used within a wider respiratory protection programme that covers selection, training, inspection, maintenance, cleaning and storage. Your risk assessment decides what combination you need.
Do I need a face fit test for a powered helmet, and what about a beard?

Powered or constant-flow equipment with a loose-fitting hood or helmet does not need a face fit test, because it does not rely on a seal against the skin. Tight-fitting masks are different and do need testing.
That does not mean fit is unimportant. The headtop still has to be the right size and adjusted properly so that the airflow stays inside the helmet and the visor sits correctly. Loose-fitting helmets can often be worn with stubble or a beard, but follow the maker's instructions and your own risk assessment, because facial hair can interfere with other items such as a tight-fitting mask worn underneath.
How do I check the airflow before I start work?

An airflow check is needed before each use, with the filters fitted and the battery fully charged. The method differs between systems: some use a flow indicator at the end of the breathing tube, others a check at the blower outlet with the tube removed, and the minimum flow figure is set by the maker.
If the reading is below the minimum, do not weld. Common causes include a loaded or blocked filter, a battery that is not fully charged, or a damaged or blocked tube or connection. Fix the cause, and if the unit still fails the check, take it out of use and have it serviced. Always follow the exact procedure and minimum figure in your manual.
What are the limits of a powered air-purifying helmet?

A system that filters the surrounding air cannot make bad air safe to breathe. Do not use these units where the oxygen level is low, or where the contaminants are unknown or immediately dangerous. Filters are also chosen for particles, or for specific gases and vapours if a gas filter is fitted, so check that the filter type matches what is in the air.
In tanks, vessels and other confined spaces, a different type of equipment with an independent breathing air supply may be needed, and the space may need to be tested first. Your risk assessment and the maker's instructions decide this.
How often should the system be inspected and tested?

Respiratory protective equipment should be thoroughly inspected before each use, and reusable equipment should have regular examination, maintenance and testing, with records kept. The intervals and how long to keep the records depend on the equipment and your risk assessment, so confirm them with the maker or a competent person.
In practice, look over the headtop, visor, seals, breathing tube, belt, blower, filter housing and battery contacts. Replace anything cracked, torn or loose rather than patching it, and make sure each wearer knows how to do the check.
How should I look after the battery?

Battery condition has a direct effect on airflow, so follow the maker's instructions for charging, storage and replacement. Storage and use conditions vary significantly between makers, excessively high temperatures can reduce battery capacity during both storage and use, and a battery that is damaged, leaking or bulging should not be used. A poorly stored battery can let airflow drop below the required level.
Charge the pack as the maker directs before a shift, keep it away from heat and sunlight, and use only the charger specified for that pack. Check your manual for long-term storage and disposal, and replace the pack when the run time becomes too short to cover your work.