WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

Material Handling

  • PB1 Pipe Buggy

    Pipe Buggy

    Rapid ref : PB1
     
     


    £ 257.60 EX VAT
     

Material Handling FAQs

Straight answers to the questions people ask most when choosing and using a cart or trolley for moving pipe and materials.

How do I choose the right load capacity for a pipe cart?icon-minus-redicon-plus-red

Work out the heaviest load you will realistically carry, including pipe, fittings and anything else on the bed, then choose a cart whose rated load is comfortably above it. The rating is normally marked on the cart or given in its instructions, so check the plate and the manual rather than assuming.

Also check the rating of the wheels, the length and width of the bed against your longest pipe, and that the load will sit evenly. Under the work equipment regulations, equipment has to be suitable for the job it is used for, so a cart used beyond its rating is not suitable.

Should I choose air-filled or solid wheels?icon-minus-redicon-plus-red

It mostly depends on the ground. Air-filled (pneumatic) tyres cushion shocks and roll better over gravel, grass and uneven yards, but they can puncture and need their pressure checking. Solid tyres never go flat and are usually better for hard, smooth floors and heavier loads, but they can feel harsh and dig in on soft ground.

Do not mix wheel types on one cart. Whatever you choose, check the wheel's own load rating, and note that figures from different makers vary, so use the maker's rating for your cart.

Does the floor or ground I'm working on matter?icon-minus-redicon-plus-red

Yes, a lot. The HSE points out that small bumps, debris and slight slopes can have a very significant effect on the force needed to push a wheeled load. A route that looks fine can be much harder work with a full load.

Clear debris, fill or avoid holes, plan the route to avoid steep slopes and kerbs, and keep floors dry and clear. Where conditions vary, such as yards and outdoor areas, a proper assessment of the pushing and pulling task is better than guessing.

How should I load pipe on a cart so it stays put?icon-minus-redicon-plus-red

Place the pipe so the weight is spread evenly and kept low, with the heaviest pieces at the bottom and centred. Use any stops, side posts, chocks or cradles to stop pipe rolling, and secure the load with suitable straps or ties before moving off.

Do not overload, do not stack pipe higher than the cart is designed to take, and keep the overhang of long pipe within what the maker allows. Release straps carefully, because loose pipe can roll. Always follow the cart manufacturer's loading instructions and your own risk assessment.

Is it safe to push a heavily loaded cart by hand?icon-minus-redicon-plus-red

It can be, but it needs thought. The law does not set a specific weight limit for manual handling; instead the HSE expects you to avoid hazardous handling where reasonably practicable and reduce the risk if you cannot. Pushing and pulling wheeled loads such as trolleys and carts are covered in the same way as lifting and carrying.

A wheeled cart is usually far better than carrying pipe by hand, but think about the load, the route, slopes, the person pushing and whether a second person is needed. HSE publishes a simple assessment tool for pushing and pulling tasks.

How do I look after a pipe cart and know when it needs attention?icon-minus-redicon-plus-red

Check it before use for bent frames, cracks, loose fixings, damaged handles, worn or flat tyres and wheels that bind or wobble. Keep bearings and swivels clean and lubricate them as the maker advises, and keep tyre pressures right on air-filled wheels.

Work equipment has to be kept in efficient working order and good repair, and inspected where it could deteriorate in a way that creates danger. How often you check depends on how hard and where the cart is used, so set it in your risk assessment. Take a damaged cart out of use until it is repaired.