PS Accessories FAQs
Answers for choosing and using saw blades, clamping jaws, feeders, lubricant, cables and laser kits for orbital pipe cutting saws.
What accessories does an orbital pipe cutting saw use?

Typical accessories are saw blades, clamping jaws and extension jaws for different pipe sizes, a pipe feeder or support, blade lubricant, a mains cable and sometimes a laser alignment kit.
The saw clamps onto the pipe and the blade travels around it, so the jaws and blade have to suit both the machine and the pipe. Check your machine's manual or data plate for the parts it takes, and give the exact model when you ask for spares.
Do I need a different blade for stainless steel?

Usually yes, or at least a blade made for the job. Blades for stainless steel are normally made from a tougher high-speed steel grade so that they last and leave a better finish, and they work best with the right lubricant and feed.
Check the blade's markings or data sheet to see which materials it is made for, and do not use one blade for carbon steel and stainless steel unless the maker says it is suitable.
How do I choose clamping jaws?

The jaws must suit the diameter range of the pipe you are cutting, and fit your machine. They close towards the centre of the pipe to hold it concentric, which helps the cut stay square without distorting the pipe.
Extension jaws are used where the standard jaws do not cover your pipe size. Make sure all jaws are the correct set, clean and fully tightened before you start cutting.
What is a pipe feeder or support for?

Long or heavy pipes tend to sag or swing as the cut goes through, which can pinch the blade or leave an out-of-square end. A feeder or support holds the pipe steady and, on some systems, moves it along to the cutting position.
Pick one that suits the pipe length and weight, set it up level with the saw, and keep it clear of the blade path.