WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790085228  

    Orbitalum WH5-U-20° Tool Holder for J-prepping U-seam, 20° Prep Angle (for BRB 2)
    790085228

    £172.00  EX VAT
     Buy in 3 easy interest free payments of £57.33† with

    Orbitalum WH5-U-20° tool holder for J-prepping U-seam, 20° prep angle, 5mm max wall thickness, for BRB 2.

    BRB 2 Tool Holders FAQs

    Answers to common questions about tool holders for portable orbital pipe and tube end-preparation machines.

    How do I choose the right tool holder for the weld preparation I need?icon-minus-redicon-plus-red

    Start with the joint you want to produce: a square (I-seam) face, a V bevel, or a curved J or U preparation. Each needs a differently shaped cutting edge, so the holder and its bit are normally chosen as a pair for that preparation.

    Then check the tube or pipe wall thickness, outside diameter and material, plus how the machine clamps the work. The weld procedure or your welding engineer should say which preparation and angle are required. If you are unsure, our team can help you match a holder to the job.

    What is the difference between I-seam, V and J (U) preparations?icon-minus-redicon-plus-red

    An I-seam is a plain square-cut face butted together; it is not strictly a bevel and suits thin walls. A V bevel is a straight angled face that forms a V when two ends are joined. A J (or U) preparation has a curved lower face and a land, so it needs less weld metal on thicker walls and is often preferred for orbital welding.

    J preparations are harder to machine than V bevels, which is why a dedicated holder and bit is used. The right choice depends on wall thickness, material and the weld procedure.

    How tightly should I fasten the bit into the holder?icon-minus-redicon-plus-red

    Tighten bit clamping screws to the setting the holder maker gives, ideally with a torque wrench or the correct key supplied. Too little tightening lets the bit move, causing vibration and a poor finish. Too much can break the screw or the bit and damage the holder seat.

    A light smear of suitable lubricant on screw threads can help stop them seizing, and any worn or damaged screw should be replaced. The correct figure for your holder is in the manufacturer's instructions.

    Why does the bit sometimes chatter or leave a rough finish?icon-minus-redicon-plus-red

    Chatter usually comes from something loose, worn or sticking out too far. Common causes are a worn cutting edge, a bit not seated or tightened properly, too much overhang from the holder, feed that is too heavy, or a workpiece that is not clamped firmly.

    Keep the bit projecting as little as the job allows, make sure the tube is held securely, and replace dull bits rather than pushing on. If chatter continues, reduce the feed and check the holder seat for wear.

    Shop Similar Categories