WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790085236  

    Orbitalum WH5-V30° Tool Holder for Bevelling, 30° Prep Angle (for BRB 2 Machines)
    790085236

    £172.00  EX VAT
     Buy in 3 easy interest free payments of £57.33† with

    Orbitalum WH5-V30° tool holder for bevelling V-seam and Y-seam. 30° prep angle, 5mm max wall thickness, for BRB 2 machines.

    BRB 2 Tool Holders FAQs

    Answers to common questions about tool holders for portable orbital pipe and tube end-preparation machines.

    How do I choose the right tool holder for the weld preparation I need?icon-minus-redicon-plus-red

    Start with the joint you want to produce: a square (I-seam) face, a V bevel, or a curved J or U preparation. Each needs a differently shaped cutting edge, so the holder and its bit are normally chosen as a pair for that preparation.

    Then check the tube or pipe wall thickness, outside diameter and material, plus how the machine clamps the work. The weld procedure or your welding engineer should say which preparation and angle are required. If you are unsure, our team can help you match a holder to the job.

    How tightly should I fasten the bit into the holder?icon-minus-redicon-plus-red

    Tighten bit clamping screws to the setting the holder maker gives, ideally with a torque wrench or the correct key supplied. Too little tightening lets the bit move, causing vibration and a poor finish. Too much can break the screw or the bit and damage the holder seat.

    A light smear of suitable lubricant on screw threads can help stop them seizing, and any worn or damaged screw should be replaced. The correct figure for your holder is in the manufacturer's instructions.

    Why does the bit sometimes chatter or leave a rough finish?icon-minus-redicon-plus-red

    Chatter usually comes from something loose, worn or sticking out too far. Common causes are a worn cutting edge, a bit not seated or tightened properly, too much overhang from the holder, feed that is too heavy, or a workpiece that is not clamped firmly.

    Keep the bit projecting as little as the job allows, make sure the tube is held securely, and replace dull bits rather than pushing on. If chatter continues, reduce the feed and check the holder seat for wear.

    Do I need different tooling for stainless steel tube?icon-minus-redicon-plus-red

    Stainless steels, particularly austenitic and duplex grades, work-harden when the tool rubs rather than cuts. Use sharp bits with suitable geometry for the material, keep a steady feed rather than hesitating, and change bits regularly because a worn edge makes work hardening worse.

    A generous flow of suitable cutting fluid is also recommended. Keep the tool overhang short and clamp the tube firmly. Check the maker's guidance for your bit and material, and try a test piece first.

    Shop Similar Categories