HMT TCT Burrs FAQs
Straight answers on choosing, fitting and using tungsten carbide rotary burrs for deburring, shaping and weld dressing.
What are tungsten carbide (TCT) burrs used for?

TCT burrs are rotary files that run in a die grinder or similar high-speed tool. They remove material from metal quickly and are used for deburring cut edges, chamfering, shaping, blending and cleaning up welds, as well as enlarging or finishing holes and working into awkward corners.
Carbide stays hard at working temperatures, so a burr usually outlasts an ordinary steel file or a grinding stone on the same job. Always match the burr to the material and the shape of the job, and follow the burr and grinder makers' instructions.
How do I choose the right burr shape?

Pick the shape that fits the surface you are working on. A cylinder, with a flat or rounded end, suits flat surfaces, edge deburring and weld removal. A ball suits concave cuts, hollowing and rounding edges. A tree (pointed or rounded) is used for V-grooves, fillets and curves, and a flame reaches tight areas while still working larger surfaces. A cone is handy for chamfering and deburring in narrow spaces.
If you are unsure, a mixed set of common shapes is a sensible starting point. Shape letter codes differ between makers, so check the description rather than relying on the code alone.
What protective equipment do I need when using a burr?

Wear eye protection every time, because chips and sparks fly off at high speed. Burr makers also recommend hearing protection, a dust mask, and protective gloves, and say the tool should be held with both hands. Keep guards in place where fitted and secure the workpiece so that it cannot move.
A carbide burr screaming against metal is loud, so do not skip ear protection on longer jobs. Your risk assessment and the manufacturer's instructions decide exactly what you need for your task.
How do I fit a burr in the grinder correctly?

Make sure the shank diameter matches the collet. Do not mix metric shanks with inch collets, as a burr that looks close can work loose and be thrown out even when tightened firmly. Push the shank well into the collet so that only the head and as little shank as possible is exposed, and keep at least the minimum grip the grinder maker specifies.
Tighten the collet properly, then run a new burr briefly in a safe position, away from people, before starting work. Stop at once if there is excessive vibration.