WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790042464  

    Orbitalum Performance Saw Blade with additional borehole, Ø 68mm, 1.2 - 2.5mm cut thickness
    790042464

    £37.50  EX VAT
     Buy in 3 easy interest free payments of £12.50† with

    GF Performance Sawblades FAQs

    Practical answers on matching, feeding and looking after mid-grade orbital pipe-cutting saw blades for tube and pipe.

    What happens if I use a blade on a wall that is too thin for it?icon-minus-redicon-plus-red

    When a coarse blade cuts a thin wall, only one or two teeth are in the material at any moment. Each tooth then takes a heavy load as it enters and leaves the tube, which can strip teeth from the blade or dull it early. Makers' guidance is to choose a pitch that keeps several teeth, commonly two to four, engaged in the cut.

    If you see chipped or missing teeth on a blade that has only done a few cuts, check first that its stated wall range matches your tube, and that the feed is not too heavy.

    How do I choose the blade diameter?icon-minus-redicon-plus-red

    Blade diameter is usually set by the machine, so start with the machine's data plate and manual to see which diameters it accepts. Within that, machine makers advise using the smallest blade diameter and the coarsest pitch that is practical for the material and the speed involved.

    The diameter also needs to be large enough to clear the tube you are cutting, so look at the maximum tube size the blade is stated to suit. A blade that is too small will not pass through, and one the machine was not designed for can be unsafe to run.

    How should I feed the blade when cutting stainless steel?icon-minus-redicon-plus-red

    Feed slowly and steadily. Machine makers advise using the slowest speed setting and a cobalt-type high speed steel blade for stainless steel, and say the rate of feed affects both the quality of the cut and the life of the blade. When feeding by hand, keep a steady, continuous pressure rather than forcing the blade through, because forcing can damage or break it.

    On many orbital saws the handwheel is there precisely to give smooth, controlled feed. Take the speed and feed ranges for your machine from its manual.

    Why does stainless steel dull a blade faster, and how do I avoid it?icon-minus-redicon-plus-red

    Stainless steel work hardens: heat and pressure from a tool that is rubbing rather than cutting can make the surface harder, which then wears the next teeth even faster. Tool makers advise keeping tools sharp, running a suitable feed so the teeth cut instead of rub, and keeping the tool moving rather than letting it dwell in the cut.

    In practice that means a steady feed (no stopping partway through), a cobalt-grade blade where the maker recommends one, and replacing the blade once it stops cutting cleanly.

    Shop Similar Categories