WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : ASX.X  

    Aluminium Expanding Pipe Stopper, 1 1/2 - 20" (38 - 508mm)
    ASX.X

    Select Option 
    Prices From £10.18 ex VAT

    Expandable test plugs for purging and general pipe blocking Pipe stoppers, or drain plugs as they are sometimes known, are used to temporarily seal the end of a pipe or opening for many different testing applications. Pipe stoppers are mainly used to seal off water, gases and foreign objects in newly laid pipes, or pipework systems that are under repair.

    To complement the range of nylon expanding plugs, we offer all sizes of aluminium plugs. These are provided in sizes from 1.5” upwards and are suitable for more arduous duties such as immersion in chemicals and/or higher temperatures.

    Brochures & Manuals

    BROCHURES & MANUALS
       View Brochure

    Stoppers FAQs

    Answers on expanding and inflatable pipe stoppers used to seal the ends of a pipe for gas purging while you weld.

    How do I choose the right size of stopper?icon-minus-redicon-plus-red

    Measure the internal diameter of the pipe, not just the nominal size, because wall thickness changes the bore. Makers list each stopper against an internal diameter range, so pick one whose range covers your pipe, ideally with the pipe somewhere in the middle of the range rather than at an extreme.

    Check the range stated on the stopper or its data sheet. An out-of-round pipe, internal weld bead or scale can stop a stopper sealing properly.

    Can I rely on a pipe stopper to stop purge gas leaking out?icon-minus-redicon-plus-red

    No. The HSE says the seal on dams and bladders should not be relied on to prevent gas leakage, and that purging gas leaking or being discharged can accumulate in confined spaces. Always provide a proper vent path and a safe place for the gas to go.

    If you are working in or near an enclosed space, follow your risk assessment, ventilation and gas monitoring arrangements, and the safe system of work for that job.

    Is there an asphyxiation risk when purging pipework with argon?icon-minus-redicon-plus-red

    Yes. Argon and other inert purge gases are heavier than air and can displace oxygen, particularly in low or enclosed areas, and you may not notice before you lose consciousness. The HSE highlights gas building up inside fabrications and confined spaces.

    Plan where the gas will vent, ensure ventilation, use oxygen monitoring where your risk assessment requires, and never use oxygen to improve the air. Follow the maker's instructions.

    Why must the pipe be vented, and how do I stop a stopper blowing out?icon-minus-redicon-plus-red

    Purge gas needs somewhere to go. Makers build vents or exhaust ports into purge dams so air can leave as the gas flows in, and welding guidance warns against over-pressurising the pipe, which can cause weld defects. Too much flow also causes turbulence that pulls air in.

    Keep the vent open and the flow low, and make sure the stopper is correctly sized and fully tightened or inflated to the maker's instructions, because pressure behind a stopper can push it out.

    Shop Similar Categories