WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : CK-325AHSF  Mfr Ref : 325AHSF

    CK Argon Hose 3 Series 7.8m (25ft) Superflex
    325AHSF CK-325AHSF

    £42.58  EX VAT
    SSP Suggested Selling Price = £85.15  YOU SAVE £42.58
     Buy in 3 easy interest free payments of £14.19† with

    SuperFlex.

    CK300 Torch Parts FAQs

    Practical answers on choosing, fitting and looking after the torch body, hoses, power cable and back cap for a large water-cooled TIG torch.

    Why must coolant be flowing before I strike an arc?icon-minus-redicon-plus-red

    In a water-cooled torch the coolant carries heat away from the power cable and torch head. A torch maker's manual warns that insufficient coolant flow can cause permanent damage to the torch, and tells the user to check the cooling function before use. Liquid-cooled cable assemblies can also leak if they overheat.

    Before welding, switch the cooler on, check the coolant level and look for coolant returning to the cooler and for leaks at the fittings. Poor flow can come from a blocked filter, a kinked line, crossed connections or a clogged fitting. If the cooler has a flow switch or alarm, never bypass it.

    Why does the power cable inside a water-cooled hose fail, and which way should the coolant flow?icon-minus-redicon-plus-red

    In many water-cooled torches the power cable runs inside the coolant return hose, so coolant passes along it on its way back to the cooler. A torch maker's troubleshooting guide says that when water-cooled leads wear out quickly you should verify the coolant flow direction: the return flow must be on the power cable lead. Another maker's manual warns that if the coolant connections are crossed the torch may overheat.

    Constant flexing can also wear the cable. A cable that runs hot, feels stiff or leaks at the fitting should be checked and normally replaced rather than patched.

    What coolant should I use in the cooler?icon-minus-redicon-plus-red

    Use the coolant specified by the cooler and torch makers. Advice differs: one trade article says to use only distilled water or an approved welding coolant and never city water, anti-freeze or rust inhibitors, while a torch maker's manual says not to use deionised or demineralised water. Tap water is widely discouraged because it can leave deposits, cause corrosion and clog the torch.

    Do not mix coolant types or add other additives unless the manual says so, and drain and refill at the interval it gives. Dirty or degraded coolant is a common cause of clogged torch fittings. If the manuals for the cooler and the torch disagree, ask the makers which coolant to use.

    How do I check for gas leaks in the torch and hoses?icon-minus-redicon-plus-red

    Air drawn into the gas stream causes porosity. A welding-equipment maker's troubleshooting guide lists a defective gas hose or loose connection among the causes and says to check hoses and connections for leaks. Common places are the back cap O-ring, the torch head seals, loose fittings and a damaged or kinked gas hose.

    With the gas on, brush leak-test solution or soapy water on each connection and look for bubbles, or close the gas at the regulator and watch for a pressure drop. Wipe the solution off afterwards and replace any damaged hose rather than taping it.

    Shop Similar Categories