WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : MKC-ETOP2  

    HMT VersaDrive STAKIT Half Top Case
    MKC-ETOP2

    £39.48  EX VAT
    SSP Suggested Selling Price = £46.45  YOU SAVE £6.97
     Buy in 3 easy interest free payments of £13.16† with

    The new STAKIT Half Top Case takes either:

    • 1 x Large InsertFoam

    Or

    • 2 x Small InsertFoams

    Customisable to each application, these sets can grow as you add to your STAKIT system. This case will clip to other Top cases or onto any EMID box.

    Related Items

    HMT VersaDrive STAKIT Top Cases FAQs

    Practical answers on choosing and using top cases for impact drilling, reaming, threading and rivet removal bits.

    What is an impact reamer used for?icon-minus-redicon-plus-red

    On steel structures, holes in joining members are sometimes slightly out of line. A reamer removes a little material so the holes line up and the bolt can pass without force, and a tapered tip helps it enter holes that are not quite aligned.

    It is for correcting small misalignments, not for drilling new holes. Take off only the minimum needed, because enlarged holes can affect the joint. On structural steelwork, check the project specification and ask the designer or engineer before reaming, and do not use a reamer to cover up badly mismatched holes. Not every reamer is built for impact driver use, so check the maker's information.

    How do I remove a rivet with a drill?icon-minus-redicon-plus-red

    The usual method is to drill into the rivet head only, as far as the surface of the metal, so the head can be removed. The remaining shank is then driven out with a punch slightly smaller than the shank.

    The aim is to avoid distorting the metal or elongating the rivet hole, so keep the drill square to the work, drill no deeper than needed and support the part so it cannot move. Wear eye protection, and check the repair instructions for the equipment first, as some jobs call for a specific method.

    Do I need cutting fluid when drilling stainless or tough steel?icon-minus-redicon-plus-red

    Using an adequate supply of cutting fluid or coolant is good practice when drilling tough materials. Stainless steel in particular is far more prone to work hardening than ordinary steel, which makes the next cut harder and wears the bit faster.

    Keep the bit cutting a proper chip with a steady feed rather than letting it rub or dwell in the hole, because rubbing and repeated pecking tend to harden the surface. Clear swarf regularly, and apply fluid as the maker directs. Check the cutting fluid's safety data sheet before use.

    How long can I use an impact tool before vibration becomes a concern?icon-minus-redicon-plus-red

    There is no single safe time, because it depends on the tool, how it is used and the person. HSE gives a rough guide that hammer-action tools used for more than about 15 minutes a day, or some rotary and other action tools for more than about an hour a day, may mean a vibration exposure problem. Real limits depend on the maker's vibration data.

    Watch for tingling and numbness in the fingers, not being able to feel things, or loss of strength in the hands, and report them early. Check the maker's vibration figures and your employer's risk assessment, and plan job rotation and breaks to cut the time the tool is actually running.

    Shop Similar Categories