Straight answers to the questions people ask most when choosing and setting up a MIG welding machine.
What is the difference between a synergic and a manual MIG welder?

On a manual machine you set the wire speed and the voltage separately, and you need to find the right balance for the wire, gas and metal. On a synergic machine you choose the wire type, wire size and gas, then set a single control such as current or metal thickness. The machine picks a matching voltage and wire speed, and you can usually fine-tune from there.
Synergic machines are quicker to set up and more repeatable, especially for less experienced users or when you change jobs often. Manual machines are simple, and many experienced welders like the direct control. Either can make excellent welds.
What does pulse MIG do and do I need it?

Pulse MIG switches the current rapidly between a high peak and a lower background level, so the metal crosses the arc in a more controlled way. Users often report less spatter and better control, which can help on thin material, aluminium, stainless steel and out-of-position welding, though results depend on the machine and settings.
It needs a pulse-capable machine and a suitable gas. Pulsed transfer cannot use pure carbon dioxide, and argon-based mixtures are normally used. For general welding of mild steel in a workshop, a standard machine is often all that is needed. Pulse is worth considering if you weld aluminium or stainless steel regularly or want to reduce cleaning and distortion.
Do I need a single-phase or a three-phase MIG welder?

It depends on the power supply you have and the work you do. Single-phase machines run from a normal supply and are common in workshops and for lighter fabrication. Three-phase machines are usually found at higher outputs for heavier duty and long continuous running, and they draw their power more evenly from the supply.
Check what supply the premises has before choosing. Higher-output single-phase machines can need a heavy supply and a suitably rated cable and protection, so look at the input current. If you have a three-phase supply, it is usually the better route for heavy, continuous production welding.
Can a MIG welder run from a 110v supply?

Yes. Some machines are designed for 110v, and many multi-voltage machines accept 110v as well as 230v. Reduced-voltage supplies are common on UK construction and industrial sites for safety reasons, so a 110v machine is practical where one is required.
The trade-off is that a 110v supply can provide less power, so the output, and the thickness of metal you can weld well, are usually lower than the same machine gives on 230v. Check the maker's output figures at each voltage, and make sure the supply, such as a site transformer or a suitable generator, can provide the current the machine draws.
Can a MIG welder weld thick steel properly?

Yes, with enough output and the right technique. A machine with adequate power and a good duty cycle can weld thick material, often in several passes. The concern with thick steel is fusion: if the arc is too cool or the technique is poor, the weld can sit on the surface without fusing into the joint, which is a serious defect.
Prepare thick joints with a suitable bevel, use enough current, keep the joint clean and follow a written procedure for important work, which may include preheating. For structural or pressure work, qualified welders and approved procedures are usually required.
What is a multi-process welder and is it as good as a dedicated MIG machine?

A multi-process machine can run more than one welding process, typically MIG, TIG and stick, from a single power source. That makes it flexible if you do varied work or want one machine for a small workshop or mobile use.
The quality of the MIG performance depends on the model, and many modern multi-process machines weld very well. A dedicated machine can have more refined settings for heavy production use. The TIG capability on multi-process machines is often DC only, so check this if you need to weld aluminium. Think about which process you will use most, and check that the machine gives the control and output you need for it.