WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790093060  

    Orbitalum Mobile Air Unit DWE 10
    790093060

    £535.00  EX VAT
     Buy in 3 easy interest free payments of £178.33† with

    Mobile Air Unit DWE 10.

    Lubricator and air filter adjustable pressure range 0 - 10 bar. Flow max 2.6m³/min (91.8 cfm). Air inlet side: ½" clutch coupling (DIN 3481). Air outlet side: ½" quick coupling. Suitable for air hose 790093061, Click Here to View.

    Related Items

    Orbitalum Accessories for BRB / REB machines FAQs

    Answers on the clamping, lubrication and air-supply accessories used with portable pipe end preparation machines.

    What are the health risks of cutting fluids and how do I reduce them?icon-minus-redicon-plus-red

    The HSE says skin contact with metalworking fluids can cause dermatitis, mainly on the hands and arms, and that breathing in the mist can cause lung problems such as occupational asthma. Its key messages are to prevent or limit skin contact, to prevent or control airborne mist, and to keep the fluid in good condition.

    In practice that means using only the amount you need, avoiding soaked clothing, washing fluid off the skin, and reading the product's safety data sheet. Your risk assessment should decide what protective equipment and ventilation are needed.

    Why is the bevel angle and finish important before welding?icon-minus-redicon-plus-red

    Bevelling the pipe ends gives access to all parts of the joint, so the weld can fuse properly right through. Single-sided joints need dimensionally accurate preparation and fit-up, the included angle is what matters for access, and if the angle or gap is too small there is not enough room to hold a correct arc length.

    The angle, root face and gap that you need are set by your weld procedure and the standard for the job, so check those before you set up the machine. A clean, even, burr-free finish also helps the pipe ends fit together properly, so check the finished prep before you move on.

    What are optional clamping wedges for?icon-minus-redicon-plus-red

    Clamping wedges are the parts that actually contact the pipe bore. A standard set covers a stated range of bore sizes, and makers list optional wedge sets specifically for extending that range, each shown against the pipe inside diameter it suits, so the same machine can take larger bores.

    Choose them by the inside diameter of the pipe, which depends on the outside diameter and the wall thickness, not by the nominal pipe size alone. Measure the bore if you are unsure, and check the machine's manual for which wedge set matches which bore range. Do not use a set outside its stated range.

    Why use cutting fluid when preparing stainless steel?icon-minus-redicon-plus-red

    Austenitic stainless steel work hardens, and its chips carry away little heat, so heat stays at the cutting edge and shortens tool life. Machining guidance says coolant is almost always crucial for these grades. Makers of pipe end preparation machines supply a water-soluble synthetic cutting fluid for this reason, to increase the service life of the cutting inserts.

    Use the fluid the machine maker recommends. Keep it off the surfaces that will be welded, and clean the pipe end as your weld procedure requires, because the weld preparation must be clean. How much to apply depends on the machine and the job.

    Shop Similar Categories