WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 2040EX-SET1  

    HMT VersaDrive ImpactaBite LH Drill & Stud Extractor 8 Piece Set (M6 - M20)
    2040EX-SET1

    Click here to see what's included

    £190.10  EX VAT
    SSP Suggested Selling Price = £223.65  YOU SAVE £33.55
     Buy in 3 easy interest free payments of £63.37† with

    Premium specification drill bits with left-handed spiral flute. 8% Cobalt with advanced TiAln coating to reduce friction and heat generation. It can be used both on Rotary and Impact settings.

    To be used for drilling the pilot holes in broken bolts and seized studs ready for VersaDrive® Bolt extractors. It is designed to run in reverse to help loosen the seized item while creating the pilot hole.

    HMT Drill Bits FAQs

    Answers to common questions about choosing and using cobalt, impact and general purpose drill bits for steel.

    How should I drill stainless steel without ruining the bit?icon-minus-redicon-plus-red

    Stainless steel work hardens when it gets hot or when the bit rubs instead of cutting. Use a sharp bit, a moderate speed, and a firm, steady feed so the bit keeps cutting. Do not let it dwell or rub in the hole.

    Use cutting fluid and watch the swarf: good chips are clean spirals, and dark or powdery chips mean too much heat. Narrow bits need a minimum speed, while larger bits and deep holes should run slower. Check the bit maker's speed chart for your grade of stainless, and clamp the work firmly.

    What loose clothing, hair or glove precautions apply when drilling?icon-minus-redicon-plus-red

    Drills are rotating machinery, and entanglement is a serious risk. The HSE advises avoiding loose or baggy clothing, tying back or covering long hair, and avoiding jewellery, including rings, when operating engineering machinery. It also says many serious workshop accidents could be avoided if gloves were not worn near rotating machinery such as drills and lathes.

    Follow the instructions for your drill or drilling machine and your own risk assessment. Keep hands clear of the bit while it is turning.

    Do I need cutting fluid when drilling steel, and how do I use it?icon-minus-redicon-plus-red

    For steel, and especially stainless, cutting fluid is normally worthwhile. It carries heat away, reduces friction and helps the swarf clear. Apply it continuously if you can, or stop regularly to reapply it, rather than letting the bit run dry.

    Use a proper cutting oil or metalworking fluid; thin sprays tend to evaporate quickly. Aluminium and brass can often be drilled with a light lubricant or dry, depending on the material and the job. Follow the bit maker's advice for the material you are drilling.

    What is the difference between cobalt and standard HSS drill bits?icon-minus-redicon-plus-red

    Cobalt steel is a variation of high speed steel with a higher cobalt content, usually described by grades with roughly 5 and 8 per cent cobalt. The cobalt gives much better red hardness, meaning the bit keeps its hardness at high cutting temperatures, so cobalt bits suit tough jobs such as stainless steel, hard steel, cast iron and high-tensile bolts.

    Standard HSS is usually adequate for mild steel, aluminium, brass and plastics. Cobalt bits are often a little more brittle, so avoid side-loading them and do not drill at an angle. Because grades vary, check the markings and the maker's guidance for your material.

    Shop Similar Categories