ESAB GCE Gas Torch Parts FAQs
Replacement nozzles, heating tips, mixers and elbows for oxy-fuel torches: how to identify the right part and keep the torch working safely.
How do I choose the right size of cutting nozzle?

The diameter of the cutting oxygen hole is chosen according to the thickness of the material. Thicker steel needs a larger cutting orifice and more preheat, so the nozzle size has to suit the job.
Nozzle size numbers are not standard between makers, so do not rely on the number alone. Use the chart supplied with your torch, which links nozzle size to material thickness and gives the gas pressures to set. Check the maker's markings on the old nozzle, and use the same fuel gas the nozzle was designed for. If you are unsure which part you have, our team can help you identify it.
Why are some nozzles one-piece and others two-piece?

The type of nozzle depends on the fuel gas, on whether the torch is used by hand or on a machine, and on the maker's preference. Nozzles for acetylene are usually one-piece, while machine cutting may use two-piece designs.
In practice, a two-piece nozzle has an inner and outer part that fit together, and the shape of the fitting affects how the gases reach the flame. You cannot assume that different designs will swap over. Look at how the old nozzle seats in the torch head, check the manual, and replace like with like unless the torch maker says otherwise.
Can I use the same nozzle with acetylene and with propane?

Not safely as a rule. Each torch should be fitted with the nozzle for its fuel gas, so a nozzle made for one fuel is generally not the right design for another. Propane burns differently from acetylene, and nozzles for the two are usually built differently.
If you want to change fuel, you generally need the torch and nozzle designed for it, and you must check that the hoses, regulators and flashback protection are suitable for that gas as well. Check the torch maker's documentation first, and never modify nozzles or fittings to make them fit.
How do I test the torch and nozzle connections for leaks?

Use a proprietary leak detecting spray or solution made for oxy/fuel systems, and do not use soapy water or any solution containing grease or oil on oxygen systems. Never look for a gas leak with a naked flame.
Repair or replace any leaking component immediately. Check the nozzle nut and seating, the torch valves and every hose connection, and do this regularly. Equipment used in tough conditions normally needs more frequent checks. If a leak will not stop after tightening a fitting properly, take that equipment out of use and have it repaired or replaced.