Spare lenses, filters, headgear and other parts for an auto-darkening welding helmet, and how to match and look after them.
How do I find the right spare lens or filter for my helmet?

Use the helmet's label and manual to identify the range, then work from the manual's parts list, which shows each spare with its reference number. A maker's manual for a powered system says that when ordering spares you should give the product type, serial number, designation and spare part number.
Cover lenses, filters, shells and headgear are usually specific to one helmet range, and sometimes to one version of it. A part that looks similar may not fit or may not be suitable for your helmet, so match the part to your exact helmet rather than guessing from size alone. Photographs of the old part, front and back, help our team confirm a match.
What is the difference between a front cover lens and an inside cover lens?

The front cover lens is the clear plate on the outside of the filter. It takes the heat, spatter and scratches, so it is the part that wears first. The inside cover lens sits behind the filter, on the wearer's side.
Both are replaceable parts. A helmet maker's manual says the auto-darkening filter must only be used with the inner cover lens fitted, and another maker describes the outside and inside lenses as consumables to be replaced with the maker's own spares. Some ranges include different grades of front cover, such as clear, tinted or tougher types, so check which your helmet accepts in the manual.
When should I replace a cover lens?

A helmet maker's manual says to replace a cracked, scratched or pitted front cover lens regularly, and a second maker says lenses must be replaced if broken, damaged or covered in spatter to the point that vision is impaired. Replace the inside cover lens if it is damaged too.
There is no single hours or welds figure that suits everyone, because it depends on the process, the current and how much spatter you produce, so check the covers before each job. On a new cover lens, make sure the protective film has been removed, as the manual lists a left-on film as a cause of poor vision. Fit it as the manual shows.
What should I do if the filter does not darken?

Stop welding straight away. A helmet maker's manual says that if the helmet does not darken when an arc is struck you must stop welding immediately and contact your supervisor or dealer. Another maker's manual says to stop using the filter if any of its function tests fail, and warns that unprotected exposure to the arc can seriously damage the eyes.
The manual's troubleshooting list for a filter that does not darken or flickers is: a soiled or damaged front cover lens, dirty sensors, sensitivity set too low for the current, and a weak or poorly fitted battery. If none of those cures it, do not use the helmet. Never open or tamper with the filter.
How should I look after the helmet and its parts between jobs?

PPE must be properly looked after and stored when not in use, for example in a dry, clean cupboard, and reusable PPE must be cleaned and kept in good condition. Use the correct replacement parts, following the manufacturer's schedule.
Helmet maker manuals add some specifics: keep the sensors and solar cells clean, store the helmet in a cool, dry, dark place, remove the battery before long storage, and avoid setting the helmet down on its front cover lens. Carry spare lenses somewhere clean and dry. Inspect the helmet before each use and replace damaged covers, headgear or shells rather than carrying on.
What kind of battery does an auto-darkening filter use and when should it be changed?

Maker manuals for helmets of this type describe a filter powered by a solar cell plus replaceable lithium coin cells, with a battery indicator that shows when to replace them. The type and number of cells vary between helmets, so check your manual or the old cell before buying a replacement, and fit it the right way round as the manual shows.
Change the cells when the indicator shows low, or when the filter flickers or fails to switch, since the manuals list the battery among the causes. Keep spare coin cells away from children. Used cells should not go in household rubbish: take them to a battery collection point and tape the terminals of lithium batteries.