WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

HMT CarbideMAX TCT 40 Cutters

HMT CarbideMAX TCT 40 Cutters FAQs

Straight answers to the questions people ask most when choosing and using 40 depth tungsten carbide tipped broach cutters.

What is a general-purpose TCT broach cutter used for?icon-minus-redicon-plus-red

A broach (annular) cutter removes a ring of metal and leaves a solid slug, so it cuts faster and needs less power than a twist drill of the same diameter. Each cutter has a stated maximum depth of cut, normally in millimetres.

Medium-depth cutters are a general-purpose choice for structural steel sections, plate and fabrication work where holes pass through moderate thicknesses. Tungsten carbide tipped teeth keep their edge in tough materials such as stainless and high tensile steel, provided the machine is rigid.

How do I choose between single cutters, sets and starter kits?icon-minus-redicon-plus-red

Single cutters suit one-off or repeat jobs at a known diameter. Sets of several cutters with pilot pins make sense if you drill a range of common sizes, for example bolt clearance holes. A starter kit with a storage case covering a run of small to medium sizes is good for those building up a tool kit.

Look at the diameters you drill most often and pick the option that covers them with the right pilot pins included.

Which pilot pin fits my cutter?icon-minus-redicon-plus-red

Pilot pins are matched to the cutter depth series and to a diameter range. Check the diameter of your cutter against the range stated on the pin, and confirm the pin is for the same depth series.

Small diameter ranges and larger ranges often use different pins, so a pin that fits one cutter may not suit another. Packs of several pins are handy because pins are small, wear, and are easily lost or bent. Check the markings if you are unsure.

Is the cutter depth enough for my material?icon-minus-redicon-plus-red

Add up the total thickness the cutter has to pass through. For a plate, that is the plate thickness. For a box or hollow section, add both walls. For a flange with a packer or stacked plates, add everything.

The stated depth of cut should be comfortably more than the total. If the job is close to the limit, choose a deeper cutter, since a cutter driven to the very bottom of its depth can jam or fail to eject the slug. Check the depth marked on the cutter and in the maker's literature.

TCT or HSS: which is better for my work?icon-minus-redicon-plus-red

TCT cutters last longer in hard, abrasive or work-hardening materials and can cut at higher speeds on a rigid machine. They are the usual choice for stainless, thick structural steel and production drilling.

HSS cutters are tougher against vibration and are often kinder in less rigid set-ups. For occasional mild steel work they can be perfectly adequate. Choose by material, machine rigidity and how many holes you drill.

What machine should I use with TCT cutters?icon-minus-redicon-plus-red

Use a rigid magnetic drill in good condition with a clean, strong magnetic grip on flat steel, and check that the shank type matches your machine. TCT teeth chip if the machine moves or vibrates.

Annular cutters should not be used in handheld drills, because side loading can break the cutter and cause injury. Check the speed range on the data plate and in the manual for your machine and match it to the diameter and material you are cutting.