WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790048060  

    Laser Retrofitting Kit for PS 4.5 and PS 6.6
    790048060

    £100.00  EX VAT
     Buy in 3 easy interest free payments of £33.33† with

    Line laser to identify the cutting point on the tube. Easy mounting on the swivel on the PS machine. Kit contains 1 line laser, 1 laser holder with 2 fixing screws, replacement batteries and assembly instructions.

    PS Accessories FAQs

    Answers for choosing and using saw blades, clamping jaws, feeders, lubricant, cables and laser kits for orbital pipe cutting saws.

    How do I choose the right saw blade?icon-minus-redicon-plus-red

    Blade choice depends mainly on the pipe wall thickness and material. As a general rule, blades with more teeth suit thinner walls and blades with fewer, coarser teeth suit thicker walls, so that several teeth are always in contact with the cut.

    The blade diameter and bore must also fit your machine. Check the maker's blade chart for your machine, and do not use a blade that is not specified for it.

    How do I choose clamping jaws?icon-minus-redicon-plus-red

    The jaws must suit the diameter range of the pipe you are cutting, and fit your machine. They close towards the centre of the pipe to hold it concentric, which helps the cut stay square without distorting the pipe.

    Extension jaws are used where the standard jaws do not cover your pipe size. Make sure all jaws are the correct set, clean and fully tightened before you start cutting.

    Why use saw blade lubricant, and how often?icon-minus-redicon-plus-red

    Lubricant reduces friction and heat, which helps the blade last longer and gives a cleaner cut. Use only the lubricant the maker recommends for the blade, as ordinary oils can cause problems.

    The maker's manual states how often to apply it, and the interval can depend on pipe size and material, so a larger pipe or a harder material may need it before every cut. Follow the instructions for your machine.

    What is a pipe feeder or support for?icon-minus-redicon-plus-red

    Long or heavy pipes tend to sag or swing as the cut goes through, which can pinch the blade or leave an out-of-square end. A feeder or support holds the pipe steady and, on some systems, moves it along to the cutting position.

    Pick one that suits the pipe length and weight, set it up level with the saw, and keep it clear of the blade path.

    Shop Similar Categories