WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 790041016  

    Saw Blade Lubricant GF LUB, 160ml Tube Chlorine Free
    790041016

    £27.00  EX VAT

    The new chlorine-free high-performance lubricant for cutting and bevelling. Increases the tool life of the saw blade. This ecologically cutting compound is an environmentally friendly replacement for ROCOL, just with a new name and improved quality. GF LUB meets the latest environmental directives and ecological standards.

    Orbitalum Sawblade Accessories FAQs

    Straight answers on lubricants and other accessories that help orbital pipe-saw blades last longer and cut cleanly.

    What does saw blade lubricant do on an orbital pipe saw?icon-minus-redicon-plus-red

    A cutting lubricant reduces friction and heat at the teeth and helps carry away fine swarf, so the blade cuts more freely and usually lasts longer. Guidance for sawing stainless steel is to feed adequate cutting fluid to the cut rather than run dry, and the same logic applies to the small, fast-turning blades on an orbital saw.

    Lubricants for this job are usually supplied as a paste or grease in a tube so that it can be applied to the blade teeth. How much benefit you see depends on the blade, the pipe material and the wall thickness, so always follow the blade maker's advice.

    Do coated blades still need lubricant?icon-minus-redicon-plus-red

    Often yes, although less is sometimes needed. Some hard-coated orbital saw blades are described by their makers as suited to minimum or spray lubrication and as giving good life even when cooling is not ideal. That does not mean they should be run completely dry.

    Check the blade maker's instructions for the lubrication they expect with that blade and material. If the blade is not coated, or you are cutting a tough material such as stainless steel, a suitable lubricant on the teeth is normally the safer approach for tool life.

    Do I need to clean lubricant off the pipe before welding?icon-minus-redicon-plus-red

    Normally yes. Oil, grease and similar residues left on the cut end can contaminate the weld, so the pipe ends should be cleaned before welding. Stainless steel guidance recommends removing oil or grease with a suitable solvent such as acetone or alcohol, or with an alkaline cleaning solution.

    Use clean cloths and gloves, let the surface dry fully and follow your welding procedure and the cleaner's safety data sheet. Orbital welding relies on well-prepared, clean ends that fit together closely, so it is worth cleaning every cut rather than assuming the end is clean enough.

    Is it safe to apply lubricant to the blade while the saw is running?icon-minus-redicon-plus-red

    No. Apply lubricant only when the machine is stopped, switched off and isolated from its power supply, and the blade has stopped moving. HSE guidance on work equipment says machines should be properly switched off, isolated or locked off before anyone cleans, adjusts or carries out maintenance on them, and that equipment should be used in line with the manufacturer's instructions.

    Make sure the machine cannot be started accidentally while your hands are near the blade, and wear suitable gloves when handling sharp teeth. If your saw has a lubricant feature built in, follow the manual for how it should be used.

    Shop Similar Categories