WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

HMT Pilot Pins

HMT Pilot Pins FAQs

Straight answers to the questions people ask most when choosing and using pilot pins for annular cutters.

What does a pilot pin do?icon-minus-redicon-plus-red

A pilot pin sits in the centre of an annular (broach) cutter. It locates the cutter on the centre punch mark and guides the start of the cut. On machines with internal lubrication it also controls the flow of cutting fluid to the teeth, and when the cut breaks through it pushes the slug out.

The ejection is usually spring-assisted, but the spring may be in the pin or in the arbor depending on the design. Slugs can be ejected with force and are hot, so keep clear. Always fit the pin your cutter and machine call for.

How do I pick the right pilot pin for my cutter?icon-minus-redicon-plus-red

The pin must match the cutter series, the cutter's diameter range and the depth of cut. Pins are made for specific cutter families and size bands, and a pin that is too short will not eject the slug while one that is too long can foul the workpiece.

Check the cutter's markings or the manufacturer's chart, and match the pin to the cutter, not just the hole diameter. If you are unsure, our team can help you choose.

Can I use one pilot pin with different cutters?icon-minus-redicon-plus-red

Only where the manufacturer states that the pin suits more than one cutter. Pins are normally supplied for a range of diameters within a cutter series, so one pin often covers several cutter sizes.

Do not assume pins from one series fit another. Different series use different shank and length dimensions, and a poor fit can leave the slug jammed, damage the cutter or cause poor centring. Check compatibility before ordering.

What is the difference between one-piece and two-piece pilot pins?icon-minus-redicon-plus-red

Pins are made in different constructions to suit different cutter sizes and depths, and larger or deeper cutters often need a longer or multi-part pin. Which construction you need is set by the cutter and the machine, not by personal preference.

Check the data plate and manual for your machine and the cutter's markings, and use the pin they specify. Check that any multi-part pin is assembled correctly and moves freely before use.

Why is my pilot pin not ejecting the slug?icon-minus-redicon-plus-red

The commonest causes are the wrong pin for the cutter, a pin that is too short, a bent or damaged pin, or swarf and dried coolant blocking the bore. Sometimes the slug is simply stuck because the cutter has been over-fed or is blunt.

Stop the machine, remove the cutter and clean the pin and cutter bore. Replace a pin that is worn, bent or sticking. Never reach in while the machine is running, and take care as the slug and cutter can be hot and sharp.

How do I know when a pilot pin needs replacing?icon-minus-redicon-plus-red

Look for bending, wear at the tip, damage to the shank, a loose or sloppy fit in the cutter, or a pin that no longer slides freely. A worn pin can cause the cutter to wander, leaving oval holes, and may lead to broken teeth.

Pilot pins are consumable parts and protect a far more valuable cutter, so replace them as soon as you suspect wear. Many users change them regularly as part of a routine.