WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

HMT OD26 Promotions

Available for a limited time only! Offers valid until December 21st.

HMT JS26 Promotion FAQs

Answers to common questions about the impact-rated drilling, tapping, reaming, extraction and burring accessories found in these sets.

Why do I need impact-rated accessories with an impact wrench or driver?icon-minus-redicon-plus-red

Impact tools hit the fastener with a series of sharp blows, and it is the shock of each blow, more than the torque itself, that damages brittle accessories. Standard chrome sockets and similar items can break, and the fragments can strike the face, eyes and hands.

Impact-rated accessories are made thicker and from tougher, less brittle steel to take that shock, and are normally marked or finished differently. Always use accessories that the maker states are suitable for impact use, and wear safety glasses.

How should I check and look after impact accessories?icon-minus-redicon-plus-red

Inspect each accessory before every use. Look for cracks, chipped or rounded edges, worn drive ends and any flaking of the surface, and put damaged items aside rather than using them.

Keep cutting tools sharp, because blunt cutters need more force and increase vibration. Wipe them clean after use, store them in their case so edges are protected, and follow the maker's instructions. Anything that has been dropped, overheated or used beyond its rating should be treated with suspicion.

Do impact tools cause hand-arm vibration problems?icon-minus-redicon-plus-red

They can. Hand-held power tools are a known cause of hand-arm vibration syndrome. The HSE says tingling or numbness after using a power tool may be a sign of a problem, and gives a rough guide that regular use of hammer-action tools for more than about 15 minutes a day may mean an exposure problem.

Compare the vibration information supplied with tools, use the right tool for the job, keep tools and cutters in good condition, and report symptoms early. Your employer's risk assessment should cover this.

Should I wear gloves when drilling, and how should I clear swarf?icon-minus-redicon-plus-red

Be careful with gloves near rotating tools. The HSE advises that gloves should not be worn close to rotating machinery such as drills and lathes, where they can be caught. Whatever you are using, keep loose clothing, cuffs, long hair and jewellery clear of the spinning part.

Wear eye protection that suits the task. Stop the tool before clearing swarf, and use a brush or vacuum rather than your hand. Do not blow swarf away with compressed air: the HSE warns that debris can bounce back into the eyes and that there are other serious risks.

How do I avoid breaking a tap?icon-minus-redicon-plus-red

Chip build-up is a common cause of tap breakage, along with excessive torque, poor alignment and a wrongly sized hole, and it matters most in blind holes. Use a tap suited to the job, for example one designed to clear chips from the hole, and use a proper tapping lubricant.

Keep the tap square to the work, turn it steadily and do not force it. In a blind hole, leave plenty of clearance at the bottom, because driving a tap into the bottom can easily break it. Choose the correct hole size before you start.

What size hole should I drill before tapping?icon-minus-redicon-plus-red

There is no single correct drill size for a tap. The size shown on most charts gives a thread that is strong but needs quite a lot of torque to cut. A slightly larger hole gives a little less thread engagement but makes tapping easier, which is often the better choice in deep holes or tough materials.

Check the thread size and pitch, then use the maker's tap drill chart. A combined drill and tap does this in one step, so the size is built in, but the material still needs to suit the tool.