WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

Gas Hoses & Fittings

Fitted Gas Hoses

Gas Hoses & Fittings FAQs

Straight answers to the questions people ask most when choosing, fitting and looking after gas hoses and hose fittings.

What is the difference between a fitted hose and a hose sold by the length?icon-minus-redicon-plus-red

A fitted hose comes ready made, with the check valve or connector at the torch end and the nut for the regulator or arrestor at the other, all attached and tested by the maker. It saves time and removes the risk of a poorly made joint.

Hose sold by the length lets you make your own length or repair a damaged hose, using the right tails, nuts and clips for the job. It suits workshops that make up hoses regularly, but the joints must be assembled correctly and tested for leaks before use.

What bore of hose do I need?icon-minus-redicon-plus-red

The bore is the inside diameter of the hose. A smaller bore is lighter and more flexible and suits small torches, light cutting and welding. A larger bore carries more gas with less pressure drop, so it suits bigger cutting nozzles, heating work and long runs.

Using a hose that is too small for the flow can starve the torch and give a weak flame. As a rule, match the hose bore to the torch and nozzle size and to the length of hose, and follow the torch maker's advice.

What are hose tails, nuts and ferrules?icon-minus-redicon-plus-red

These are the parts that make up a hose connection. A hose tail is the barbed end that pushes into the hose, a union nut screws on to the equipment, and a ferrule or clip is crimped or clamped over the hose to hold it onto the tail.

The tail, nut and clip must all match the hose bore and the thread of the equipment, and the nut must suit the gas. Use the right clip or crimp tool for the type of joint, because a hose that works loose under pressure is a serious hazard.

Why do some fittings have left-hand threads?icon-minus-redicon-plus-red

Fuel gas connections use a left-hand thread, and oxygen uses a right-hand thread, so the two cannot be connected by mistake. Left-hand nuts normally have a notch cut around the nut so you can recognise them by touch as well as by sight.

This applies to the nuts, check valves and couplers throughout the system. Never swap parts between gases or use adaptors to force a fit. If a fitting will not thread on easily, stop and check that you have the right gas and the right thread.

What is a hose check valve and why is it fitted?icon-minus-redicon-plus-red

A hose check valve is a non-return valve fitted where the hose meets the torch. It lets gas flow towards the torch but stops it flowing backwards along the hose. This helps prevent the gases mixing in the hose and limits the damage if a backfire occurs.

It does not replace a flashback arrestor and the two do slightly different jobs. Check valves can wear or stick, so they should be tested regularly, and you must use the right one for each gas, with the correct thread.

What do the hose colours mean?icon-minus-redicon-plus-red

In the UK, the usual colours are blue for oxygen, red for acetylene and other fuel gases such as hydrogen, and orange for propane and other liquefied petroleum gases. Using the right colour makes mistakes much less likely.

The colour is a guide, not a guarantee. Hose made for fuel gas is built with a material suited to it, so never use oxygen hose on fuel gas or the other way round. Always check the markings on the hose and the fittings, and replace any hose that has been used for the wrong gas.