WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

Orbitalum Sawblade and Machine Oil

Orbitalum Sawblade and Machine Oil FAQs

Straight answers to the questions people ask most when choosing and using saw blade lubricant and gear oil for orbital tube cutting machines.

What is saw blade lubricant and why use it on an orbital tube saw?icon-minus-redicon-plus-red

Saw blade lubricant is a purpose-made paste or stick applied to the blade of an orbital tube cutting machine before the cut. Machine makers name it in their operating instructions and normally pack a tube of it with the machine. It is applied at the cutting edge rather than flooded over the work.

Its job is to reduce friction and heat at the teeth, which usually means a cleaner cut and longer blade life, particularly on tough materials such as stainless steel. Always check your manual for the type your machine needs.

How often should I apply saw blade lubricant?icon-minus-redicon-plus-red

Follow your machine's manual, because the interval depends on the machine and the tube. One maker's instructions for an orbital pipe saw say to lubricate at least every third cut on pipe up to 2 inches in diameter, and before every cut on larger pipe and on chrome-bearing or other high-quality steels. They also say to lubricate again during the work if needed.

On stainless or thick-walled tube, lubricating before each cut is a sensible habit. Always remove lubricant residue from the machine afterwards.

Can I use ordinary oil or a spray instead of saw blade lubricant?icon-minus-redicon-plus-red

It is best not to. The operating instructions for one orbital pipe saw say to use only saw blade lubricant, and specifically not oils. A thin oil may not stay at the cutting edge and can leave a film that is harder to remove from the tube and the machine.

Some machines use a separate cutting lubrication system instead of a paste, so check which your model is designed for. The wrong product can leave residues that matter when the tube is later welded.

Does lubricant residue matter before welding?icon-minus-redicon-plus-red

Yes. Surfaces in and around the joint should be clean, dry and free from organic materials, and austenitic stainless steel is very sensitive to cracking caused by contaminants such as grease. Lubricant left on a cut tube end is exactly that kind of contaminant.

Remove it from the end face and the bore before the tube goes into the weld head, using the cleaning method in your welding procedure. Handle cleaned ends with clean gloves.

Why do some buyers choose a chlorine-free lubricant for stainless steel?icon-minus-redicon-plus-red

Chlorides are the most common environmental cause of stress corrosion cracking in stainless steels, and the usual 304 and 316 types are among the most susceptible. Cutting additives containing chlorine can also form hydrogen chloride when hot, which can cause corrosion. For these reasons many fabricators of stainless tube prefer products described as chlorine-free.

It is not a guarantee against every corrosion risk. Check the product data sheet against your job specification, and still clean the tube after cutting.

Is it safe to get saw blade lubricant on my hands?icon-minus-redicon-plus-red

Treat it with care. HSE guidance on metalworking fluids says that neat oils, additives and the fine metal particles picked up in use can cause dermatitis, especially on the hands, arms, face and torso, so skin contact should be prevented where possible and limited where it cannot be.

Read the safety data sheet, wear the gloves it recommends, keep contaminated clothing away from your skin, wash after use and report any skin irritation. Your risk assessment should cover how it is handled.