WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE

9100 Series Parts

9100 Series Parts FAQs

Spare plates, filters, headbands and comfort parts for an auto-darkening welding helmet, and how to match them to your helmet.

How do I know when a protection plate needs replacing?icon-minus-redicon-plus-red

Replace a plate that is scratched, cracked, pitted or heavily covered in spatter. Makers' instructions say a damaged outer cover should be changed rather than used, because it can interfere with the auto-darkening sensors and spoil your view of the work.

Check both plates before each shift: look through the helmet at a bright, plain background, and any marks, haze or dark spots will show up. Plates are a wear item, so how often you change them depends on the process, how much spatter you create and how you store the helmet.

What is the difference between the outer and inner protection plates?icon-minus-redicon-plus-red

The outer plate is the replaceable clear cover on the front of the helmet. It takes the spatter, sparks and grinding debris, so it is the part that wears out most quickly. The inner plate sits on the wearer's side of the filter and keeps sweat, dust and fumes off the back of the filter.

Makers' instructions tell you to check both covers are clear and undamaged before use. The two are usually different shapes and are not interchangeable, so check which one you need against your helmet's manual before ordering.

Can I clean a protection plate or filter with solvent?icon-minus-redicon-plus-red

No. Makers' instructions say not to clean the front lens cover or the helmet with solvents or abrasive cleaning products, because they can scratch or cloud the surface. Use only the cleaning method in your helmet's manual, which is normally a soft, clean, lint-free cloth.

Do not immerse the filter in water either. If a plate cannot be cleaned to a clear finish, replace it rather than trying harder to clean it.

My filter will not darken or flickers. Is the filter faulty?icon-minus-redicon-plus-red

Not necessarily. Start with the simple checks: look for a scratched or heavily spattered front plate, make sure the sensors on the filter are clean and not blocked by spatter or a hat brim, and check the battery or solar cell and the sensitivity and shade settings.

Makers' instructions stress keeping the sensors clear and unobstructed so the filter can sense the arc. Some low-current work needs a more sensitive setting. If the filter still does not darken reliably after these checks, stop welding with it and follow the manual or ask the maker about a replacement filter. Never carry on and hope.

What can happen if I keep using a damaged plate or a filter that does not darken?icon-minus-redicon-plus-red

Welding radiation can injure the eyes. The HSE describes arc eye as an acute injury to the front of the eye (the cornea) caused by welding radiation, usually painful and red a few hours after the exposure. It also links welding ultraviolet radiation to a rare eye cancer, which is why it stresses protecting the eyes when welding.

A filter that fails to darken, or a cracked plate or frame that lets light in, removes that protection. Take the helmet out of use until the faulty part has been replaced.

What do the markings on a filter mean, and why do older filters show different markings?icon-minus-redicon-plus-red

Filters usually carry a light-state shade, the dark shade or range, and an optical class. Older filters and helmet frames are marked to standards that have since been withdrawn and replaced by a newer international standard series, so newer products may carry different markings.

Look at the markings on your own filter and helmet and quote them to us or the maker; do not guess the grade from how a filter looks.