Fronius MIG Parts FAQs
Straight answers to the questions people ask about MIG torch wear parts: nozzles, contact tips, insulators, diffusers and seals.
How do I choose a gas nozzle?

Nozzle shape and bore both matter. A cylindrical nozzle gives a wide gas field, which helps with materials that oxidise easily, such as aluminium and stainless steel, and suits higher currents. A conical nozzle is a common all-round choice. A bottleneck nozzle has a narrower end for reaching restricted joints.
In general, choose the largest bore that still lets you reach the joint, as higher currents need a bigger bore. Use a shorter nozzle if access is tight or spatter is heavy. Nozzles are specific to the torch series, so check fit first.
How do I choose the right contact tip for my wire?

The tip must match the wire diameter, and the bore is normally marked on the tip. A tip that is too big lets the arc wander, while one that is too small makes the wire stick or burn back. Tips also come in different lengths and thread types, so match those to your torch.
If you switch to a different wire size, change the contact tip as well as checking the liner and drive rolls. Using the wire size printed on the spool as your starting point avoids most mistakes.
What is the difference between copper tips and harder alloy tips?

Standard contact tips are made from copper, which conducts well but can soften with heat and wear. Some tips are made from a harder copper alloy, such as copper-chromium-zirconium, which holds its shape better at high temperature and resists wear from the moving wire and from electrical erosion.
Harder alloy tips are generally promoted for high-current, pulsed and long-duty work, where standard tips can soften and cause burn-back or erratic feeding. For light or occasional welding, a standard tip is often all you need. The maker's recommendation for your torch comes first.
Do I need a special contact tip for aluminium wire?

Usually yes. Aluminium wire is soft and expands more than steel as it heats, so it can drag or seize in a bore sized for steel wire. Tips made for aluminium normally have a slightly larger bore for the same wire diameter, and are often marked to show it.
The extra clearance should only be slight. A bore that is too loose gives patchy electrical contact, which can make burn-back worse. Use a tip intended for your aluminium wire diameter and keep the bore clean, because aluminium build-up inside it is a common cause of sticking. Pair it with a plastic liner and drive rolls made for aluminium, and follow your torch maker's recommendation.