WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : 0304-0011  

    GCE Type 55 Elbow 26"
    0304-0011

    £49.53  EX VAT
    SSP Suggested Selling Price = £61.91  YOU SAVE £12.38
     Buy in 3 easy interest free payments of £16.51† with

    Related Items

    ESAB GCE Gas Torch Parts FAQs

    Replacement nozzles, heating tips, mixers and elbows for oxy-fuel torches: how to identify the right part and keep the torch working safely.

    Why are some nozzles one-piece and others two-piece?icon-minus-redicon-plus-red

    The type of nozzle depends on the fuel gas, on whether the torch is used by hand or on a machine, and on the maker's preference. Nozzles for acetylene are usually one-piece, while machine cutting may use two-piece designs.

    In practice, a two-piece nozzle has an inner and outer part that fit together, and the shape of the fitting affects how the gases reach the flame. You cannot assume that different designs will swap over. Look at how the old nozzle seats in the torch head, check the manual, and replace like with like unless the torch maker says otherwise.

    Can I use the same nozzle with acetylene and with propane?icon-minus-redicon-plus-red

    Not safely as a rule. Each torch should be fitted with the nozzle for its fuel gas, so a nozzle made for one fuel is generally not the right design for another. Propane burns differently from acetylene, and nozzles for the two are usually built differently.

    If you want to change fuel, you generally need the torch and nozzle designed for it, and you must check that the hoses, regulators and flashback protection are suitable for that gas as well. Check the torch maker's documentation first, and never modify nozzles or fittings to make them fit.

    Why does my torch backfire, and what should I check?icon-minus-redicon-plus-red

    A backfire is the flame burning back into the torch, often with a sharp bang. It may happen when the torch is held too close to the workpiece, or when the nozzle is partly blocked. Backfires do not usually cause injury or damage, but can indicate a fault in the equipment.

    If one occurs, shut the torch valves (oxygen first, then fuel), close both cylinder valves, cool the torch if necessary and then inspect the equipment, especially the nozzle. Do not relight until you have found the cause. A damaged, blocked or badly seated nozzle should be cleaned or replaced.

    How do I test the torch and nozzle connections for leaks?icon-minus-redicon-plus-red

    Use a proprietary leak detecting spray or solution made for oxy/fuel systems, and do not use soapy water or any solution containing grease or oil on oxygen systems. Never look for a gas leak with a naked flame.

    Repair or replace any leaking component immediately. Check the nozzle nut and seating, the torch valves and every hose connection, and do this regularly. Equipment used in tough conditions normally needs more frequent checks. If a leak will not stop after tightening a fitting properly, take that equipment out of use and have it repaired or replaced.

    Shop Similar Categories